0
What else can I help you with?
How do you use petrol and oil mixing bottles?
I would assume that this is for mixing regular petrol with a 2-stroke engine oil. The mixing bottle normally has an initial level to fill with petrol which should be about 98% of the total volume. You then top up with 2-stroke oil to the final fill level. Therefore there should be two graduation levels near to the top of the bottle.
Does petrol soluble in kerosene?
Yes, petrol is soluble in kerosene as they are both hydrocarbon-based fuels. Mixing the two together should result in a homogeneous solution.
What happened to ramar petrol which had made news a few years back?
Ramar petrol collapsed after the owner was arrested for buying organic chemicals from the market and selling it as herbal fuel by mixing the chemicals with additives.
How are two stroke engines lubricated?
Two stroke engines are lubricated by mixing special two-stroke oil in with the petrol.
What will happen if petrol is mixed with water and stirred?
Petrol and water do not mix as they have different densities and chemical properties. The two liquids will separate into distinct layers, with the petrol floating above the water due to its lower density. It is not a safe practice as mixing them can pose a fire hazard.
Why is a motocross mixing water with the oil?
you dont mix water with oil. If you have a two stroke engine it needs oil and petrol in the tank or it will just die on you. But if you have a 4 stroke you just put petrol in the tank. Hope this helps.
Cr 85 2004 oil to petrol ratio?
should be around 32 to 1 get 2 stroke oil has mixing direction on bottle
Does kerosene and petrol form a single layer on mixing?
Yes, they can be homogeneously mixed ('one layer' fluid) in each random ratio, but not with water.
If you mix co2 with petrol in an engine what happens when it ignites?
Mixing Carbon Dioxide (fills fire extinguishers) with Gasoline will prevent ignition. So nothing
Explain the working of four stroke petrol engine?
It differs from a diesel engine in the method of mixing the fuel and air, and in the fact that it uses spark plugs to initiate the combustion process. In a diesel engine, only air is compressed (and therefore heated), and the fuel is injected into the now very hot air at the end of the compression stroke, and self-ignites. In a petrol engine, the fuel and air are usually pre-mixed before compression (although some modern petrol engines now utilise cylinder-direct petrol injection). The pre-mixing was formerly done in a carburetor, but now (except in the smallest engines) it is done by electronically-controlled fuel injection. Pre-mixing of fuel and air allows a petrol engine to run at a much higher speed than a diesel, but severely limits their compression, and thus efficiency
What is the ratio to mix 2 stroke oil with 5 liters of petrol?
The typical mixing ratio for 2-stroke oil and petrol is usually 50:1, meaning 50 parts petrol to 1 part oil. For 5 liters of petrol, you would add 100 milliliters of 2-stroke oil. However, always check the manufacturer's specifications for your specific engine, as some may require different ratios.
How do o get traces of diesel from your petrol?
To detect traces of diesel in petrol, you can perform a simple test by mixing a small amount of the fuel with water in a clear container. Diesel and petrol do not mix well, so if diesel is present, it will separate and form a distinct layer. Additionally, you can check for the characteristic smell of diesel, which is heavier and oilier than petrol. If you suspect significant contamination, consider getting the fuel analyzed by a professional laboratory.
