0
What is the proper procedure for changing your coolant in your 1997 ss lt-1 camaro?
remove rad cap. place a large pan under the car. open the drain plug on the bottom left of the radiator. loosen the 2 bleed screws. one is on top of the thermostat housing the other in a t connector next to that. after rad is drained, move pan under engine blockand remove the block drain plugs or knock sensors (which doubles as plugs on some models) on both sides of the block. disconnect reservoir hose and remove reservoir to flush it. place a hose in the ra filler neck and run til clean water flows through all drain points. install the plugs and reservoir and theres hose and rad drain plug. use the correct coolant. GM recomends adding coolant system sealeradd coolant slowly. close bleeder screws when coolant coming from them is bubble free. add to the reservoir. keep an eye on the level after a few miles and check for leaks.
What else can I help you with?
What is the proper procedure for filling the coolant system on a 1994 Chevy Camaro 3.4L?
This is difficult so pay attention- (1) Remove the radiator cap (2) Start filling the radiator with a proper mixture of water and coolant(Most climates us a 50/50 mixture) (3) Once the coolant reaches the radiator neck stop filling and let the coolant go down, you can speed this up by starting the engine and letting the coolant start to circulate. (4) keep doing this until the coolant level remains at or near the top of the radiator. Happy Motoring!
Did you ruin the engine by adding low silicate coolant in your 1999 Chevy Camaro?
What does your owner's manual say to use? If low silicate is not listed then drain and refill with the proper coolant.
What is the proper coolant temperature for my 2010 camaro?
The proper coolant temperature for a 2010 Camaro typically ranges between 195°F and 220°F (90°C to 104°C) when the engine is at normal operating conditions. It's important to monitor the temperature gauge on the dashboard; if it consistently exceeds this range, it may indicate an overheating issue. Always consult your owner's manual for specific recommendations and maintenance guidelines.
Can you reset oil change light without changing oil?
yes you can, just look in your manual for proper procedure and you are set.
Can Camaro doors be adjusted?
Yes, Camaro doors can be adjusted to ensure proper alignment and functionality. This adjustment can involve changing the position of the door hinges or the striker plate to improve the fit and prevent issues like misalignment or difficulty closing. If you're experiencing problems with your Camaro doors, it's advisable to consult a professional mechanic or body shop for precise adjustments.
How do you get windshied washer fluid out of the coolant reservoir?
Remove the coolant reservoir, flush it out, reinstall it and refill with proper coolant.
What is the proper spark plug gap for camaro 1998?
65 degrees
Is there a proper procedure for the Pledge of Allegiance?
Proper procedure? Can either hand (left or right) be used when reciting the Pledge of Allegiance.
What is the proper spark plug gap for a 350 Chevy 89 camaro?
.035
Replaced thermostat in your golf gti 1991 but still no heat why?
You must make sure that you have purged all air from the coolant system. An air bubble will not allow proper flow of coolant and could also cause the engine to overheat. Add coolant into resevior and leave top off with engine running. Add more coolant as required. If temp gets too high with cap off and coolant starts to back out of resevior, then replace cap and allow to cool. Remove cap after cool and top up coolant again and repeat procedure.
What is the proper spark plug gap for a 1979 Chevy Camaro with a 350 engine?
.035
What is the proper spark plug gap for 1990 Chevy camaro 3.1 V6?
.045"
