0
From the front of the engine right hand side second bolt back is #1, #2 is on the left side second from the back, #3 is on the right side second from the back, #4 is on the left second from the front,#5 is on the right side the front bolt,#6 is on the left side the first bolt, #7 is on the right side the back bolt, #8 is on the left side back bolt, #9 is on the right side third from the front, #10 is on the left side fourth from the front, #11 on the right fourth from the front,#12 on the left side third from the front.
What else can I help you with?
Will a 1979 ford 302 intake fit on a 1993 302 ford motor?
The intake on the 1979 Ford 302 engine is different than the intake on the 1993 Ford 302 engine. The intakes are not interchangeable.
What are the settings for torquing the intake on an 89 Ford F-150 fuel injected 89 302 motor and also the settings for th rocker arms and headbolt torque settings?
go to autozone.com put in the year, make, engine size, repair info then spefications and torque.
Will a 302 intake fit on a 351?
Unlike chevys 305, 350, and 400 which are interchangeable. The Ford 302 and 351 are not interchangeable.
Can you replace lifters in a 302 Ford engine without removing the intake manifold?
no.
Can the intake from a 302 be used to replace a broken intake on a 351 on a 1990 Ford Bronco?
No, the 351 W was a wider lifter valley and the intake will not interchange
What could cause a severe oil leak below the valve covers on a Ford 302?
intake gasket on rear of engine on top between intake and block 302's leak there alot
Will a carburetor ford intake fit on a fuel injected ford motor?
yes ,i've done it to a 302 and it ran fine
Why does my 1972 Ford Mustang with a ford 302 motor rev up and down while idling?
You have a vacuum leak at the intake.
How can you tell the diffence between a 351 and a 302 ford v8 engine?
the 351 intake is wider
Where is the PCV valve on a 1994 Ford Bronco with a 302 engine?
The pcv should be on the passenger side back behind the intake.
What is the number on intake it isD8V 9425 CB of a 302 ford?
The intake manifold part number D8V 9425 CB indicates that it is a part from the Ford Motor Company, specifically designed for the 302 cubic inch V8 engine. The "D8" prefix suggests it was manufactured in the 1970s, likely for vehicles produced in 1978. This intake is typically associated with the 302 engine used in various Ford models during that era. For specific applications or performance details, further context about the vehicle or intended use would be helpful.
Where is the intake air temp sensor 1995 ford bronco with 302 cu in?
It is important to know the location of a car's parts. The Intake Air Temp sensor is located in the housing of the air intake.?æ
