I am running the exact same combination with 0.035" gap. Good results.
Moisture is rarely a problem unless the cap is cracked. Accel offers a high performance distributor that comes with an O ring around the bottom of the cap to seal it to the distributor housing.
The two wires coming from an ACCEL distributor typically connect to the coil. One wire is for the ignition power source, while the other wire is for the tachometer. It's important to consult the manufacturer's instructions or a wiring diagram to ensure proper connection.
Yes, you can do this, by why in the world would you want to? I agree it can be done, but you will need a resistor for the hot side of the coil. Contact one of the manufacturers of aftermarket ignitions such as Accel or Mallory and ask them for the part number of the correct resistor. It goes between the wire presently connected to the BAT terminal on the HEI and the + terminal on the new coil.
350 small block Chevy Bored .030 over Lunati Bracket Master 2 Cam 292/480 3998993 72-73_307/350_76cc chambers Heads Gm Aluminum 4 Barrel Intake - 14014432 (Corvette) 80_L48 and the L82 Accel High proformance HEI distributor Accel HEI Super Coil I need To know where to set the timing?
I suggest you just purchase a pointless laser distributor from accel, there is no messing around with compatability and it looks really cool.
Accel-KKR was created in 2000.
Accel World was created in 2009.
Accel Partners was created in 1983.
when is naruto accel released in USA stores
http//:wwwdubbedanime.tv/?s=accel
Yes, they will be in Naruto Accel 3.
Accel Transmatic Limited was created in 1986.