answersLogoWhite

0

.020

User Avatar

Wiki User

11y ago

What else can I help you with?

Related Questions

What is the spark plug for the fs 36 stihl weed eater?

The spark plug for a Stihl FS36 is a Bosch WSR6F gapped at .025


What spark plug for stihl 024 chainsaw?

The correct spark plug for a Stihl 024 is an RCJ6Y (Champion), BPMR7A (NGK), or a WSR6F (Bosch). Make sure that the gap is set to 0.020 inches.


Spark plug gap for a stihl FS45 trimmer?

0.020"


What is the spark plug gap for a MS170 stihl chainsaw?

0.020


What is the correct spark plug for a Stihl 023 chaine saw?

correct plug is NGK BPMR7A


Where is the spark plug on a stihl chainsaw?

Depending on the model there should be a cover above the throttle handle. The spark plug should be under that cover.


How do you change plug in stihl 024 AV chainsaw?

To change the spark plug on a Stihl 024 AV chainsaw, first ensure the engine is cool and disconnect the spark plug wire. Use a spark plug wrench to remove the old plug by turning it counterclockwise. Install the new spark plug by hand to avoid cross-threading, then tighten it with the wrench until snug, but avoid over-tightening. Finally, reconnect the spark plug wire, and your chainsaw is ready to use.


Spark plug gap setting for a stihl chainsaw 26''?

plug gap should be .025" http://store.chainsawr.com/


What spark plug do I use for Stihl 011AVT 16-inch chainsaw?

ngk bpmr7a


How do you change the spark plug on a stihl wood boss 024 av chainsaw?

To change the spark plug on a Stihl Wood Boss 024 AV chainsaw, first ensure the chainsaw is turned off and cool. Remove the spark plug cover using a screwdriver, then use a spark plug wrench to unscrew and remove the old spark plug. Check the gap on the new spark plug, install it by hand to avoid cross-threading, and tighten it with the wrench. Finally, replace the spark plug cover securely before starting the chainsaw.


Craftsman leaf blower Model 358.797310 What is the spark plug gap?

Spark Plug gap is .025


What is a compatible spark plug for 794-00050 for troybilt grass blower?

The compatible spark plug for the Troy-Bilt grass blower model 794-00050 is typically the Champion RCJ6Y or equivalent. Always check the owner's manual or consult with a professional to ensure the correct spark plug for your specific model and engine type. Using the right spark plug ensures optimal performance and reliability of your blower.

Trending Questions
How do you change center carrier bearing 1996 T100 4x4? How do you bleed your brake system after you install new brake pads? How do i change a flat tire? Why would my 2001 Ford Focus have a rubber burning smell coming out of the air vents when the car stops at stoplights at idle? Will a Briggs oil filter part492932s cross reference to wix 57035? 2001 dodge ram 1500 5.9l engine while driving the transmission temperature warning light and overdrive light would come on then shut off once in a while what could be the problem? If your brakes go out and you slarm your foot on them does it make a noise? Speedometer not working replaced both speed sensors check engine light went out but no odometer either? How do you reset a car alarm in a Lexus 1998 es300? What size wiper blades do you use for a 1996-2002 Ford Taurus? Where is the power steering pump on a 2007 Ford Fusion? Does the 1988 Ford Thunderbird 4 cylinder turbo coupe have a timing belt or chain? 1998 transport over heating. when the temp gauge is normal heater is blowing hot when temp gauge gets hot heater blows cool replaced thermostate Why would it be over heating? Why does a computer have to be flashed when installing a new one in a vehicle? 2001 dodge caravan fuse box? Where is camshaft position sensor on 1997 subaru impreza? Can you use amsoil racing atf in a turbo 400? How do you replace serpentine belt on 2000 Seville? Is there a release for transmission fluid for 1995 ford explorer? Instructions say to run the car until temp warms up shut car off then hook up scanner and restart engine this booklet that came with it possibley just trying to say the ingnition switch shold be on?