Automatic Transmission, Others Initial Fill..........3.0 quarts [2]
Automatic Transmission, Total Fill
2wd ..........9.8 quarts
4wd ..........10.0 quarts
Manual Transmission, ..........5.5 pints
[2]. With ENG at operating temperature, shift through all gears.
Check fluid level in PARK and add fluid as needed.
Hope This Helps.
where the dipstick comes out stick a funnel right in hole and fill
12 TO 14 QUARTS
The automatic transmission fluid capacity is 5.0 quarts.
4400 lbs
On a 1993 Ford Aerostar : The automatic transmission modulator is on the passenger side of the transmission ( it might be behind a heat shield )
I checked Chilton's and Haynes manuals and they both say to use Type F Automatic transmission fluid for the power steering.
On the rear of the engine on the passenger side
1993-1996 automatic transmission: MERCON automatic transmission fluid (NOT MERCON V) 1993-2005 manual transmission: MERCON automatic transmission fluid (NOT MERCON V)
For a 1993 Dodge Dynasty, you should use ATF+4 transmission fluid, which is the recommended fluid for its automatic transmission. Always ensure to check the owner's manual for specific requirements and capacity. Using the correct type of transmission fluid is crucial for optimal performance and longevity of the transmission.
The fluid capacity of a 1993 Jeep Wrangler with a 4.0-liter engine and an automatic transmission is approximately 12 quarts when including the torque converter. It's important to check the owner's manual for specific recommendations and to verify the fluid level after a transmission service, as the total capacity can vary slightly based on the specific transmission model and any modifications.
How many quarts of transmission fluid is required to change transmission fluid in a 1993 150 Ford Van?
how to put transmission fluid in a 740il BMW 1993