0
I've never come accross a striped screw. Makes me think of candy canes. I tell you what though, I've seen quite a few STRIPPED screws. Get an "Impact Driver" from your parts store (Or tool truck). It is a screw driver that you hit with a hammer in to the screw. The impact also causes the head of the driver to rotate while being pushed in to the hole. If all else fails get yourself some sharp drill bits.
What else can I help you with?
Is a gimlet a tool?
yes its used to start off screw holes
Has the screw head broke off in the wood and you need help removing it?
Yes, if the screw head has broken off in the wood and you need help removing it, you can try using a screw extractor tool or drilling a small hole into the screw to remove it.
What do you take off the governor on a pocket rocket and how do you do it?
you take the screw off the carbarator.
How do you take off stock of m4?
To take off the stock of an M4 rifle, first ensure the weapon is unloaded and the chamber is clear. Then, collapse the stock if it’s adjustable. Use a flathead screwdriver or a similar tool to loosen the stock retention screw located at the rear of the receiver. Once the screw is loosened, you can slide the stock off the buffer tube.
What tool you use to take a wheel off?
A lug wrench is the tool needed to take a wheel off.
How do you install a harmonic balancer in a 1977 Lincoln Continental?
take off the old one with a harmonic ballencer puller you can rent one at the tool rental store, there is a large screw holding the ballancer in place with a keyway, you losen the screw tell its almost off but not all the way and then you attach the puller to the ballencer with two screws then you turn the center screw in until the ballancer pops off ..
2006 vw passat rear brake pad replacement without scan tool?
take the motor off the backside of the calliper and turn the screw in with a allen wrench then push the piston in
How do you remove and install the inside door panel on a 1991 ford ranger?
you need to take out the screw on the arm rest, then take the screw out of the door handle, then slide off the platic piece that is around it. then the fun part the window crank... you have to pull on it because it is just a couve that is on it and when it pops off there is a nex screw and unscrew that. then u can go buy the right tool to take the panel off or you can shove in between to door panle and the door and get your fingers in there and just pull.... it is just christmass trees that are holding the door panel... hopes this helps.
How do you take off rotors on a 97 Volkswagen Passat?
Take off the caliper. Then the saddle. There will a screw holding the rotor on you will have to take that out. The best way to take it out is to buy a impact driver. But if you dont have one then just get the right screw driver and hit it with a hammer this will cause the screw to loosen.
Has the screw broke off in the wood, and if so, what is the best way to remove it without causing further damage?
Yes, if a screw has broken off in wood, the best way to remove it without causing further damage is to use a screw extractor tool. This tool is designed to grip onto the broken screw and twist it out of the wood. It is important to follow the instructions carefully to avoid damaging the wood further.
Is it easy to take on and off the Cubic Zirconia Screw Top Body Jewelry?
Yes, it comes with an easy to use screw off back.
How do you fine the oil filler in a 2009 corolla and get a tool to take it off?
how do i fine the oil filler in a 2009 corolla and get a tool to take it off
