It's an overload. It could be a shorted wire, worn out brakes or just misadjusted brakes.
Check the brake fluid reservoir, it may be low on brake fluid indicating it is time to have the brakes inspected.
apply your brakes gently while accelerating at the same time
Time for new brakes or adjustment.
it broke
apply your brakes gently as you accelerate
apply your brakes gently as you accelerate
What is stab braking?Apply your brakes all the way.Release brakes when wheels lock up.As soon as the wheels start rolling, apply the brakes fully again. (It can take up to one secondfor the wheels to start rolling after you release the brakes. If you re-apply the brakes before thewheels start rolling, the vehicle won't straighten out.)This is directly from the NYS CDL Manual.
What is stab braking?Apply your brakes all the way.Release brakes when wheels lock up.As soon as the wheels start rolling, apply the brakes fully again. (It can take up to one secondfor the wheels to start rolling after you release the brakes. If you re-apply the brakes before thewheels start rolling, the vehicle won't straighten out.)This is directly from the NYS CDL Manual.
Apply the brakes hard and steer out of danger.
No, that is not true. Water is going to get on the rotor and on the pads no matter what you do. This water will quickly evaporate once you apply the brakes. Even if you do not apply the brakes centrifugal force will remove the water as you drive. Once you apply the brakes the heat created will remove the water very quickly. You may experience a slight loss of good braking the first time you apply the brakes after going through water which is normal.
If your vehicle has abs brakes, just apply the brakes hard and steer away from danger. If the vehicle does not have abs brakes, try to apply the brakes without locking up the wheels and going into a skid then steer away from danger. If you lock up the brakes and go into a skid you will lose control of your steering.