Flash your high beams once and wait a moment. Most drivers will lower their beams. They maybe having problems though and their low beams may not even work, so take that into consideration before you give them the finger as they roll by.
There is a foot switch on the driver's floor by your left foot.
how do you turn on high beams on 1979 corvette
Your headlights turn off when you turn the high beams on because you have a defective switch. You need to have a mechanic replace the high beams switch. It is a simple replacement.
You need to turn your high beams down and ,after the car passes, you may turn them back to high beams
I dont know about the '99, but on my '95 the high beams are activated by pulling the turn indicator lever towards the driver. Pushing it forward turns them off again.
Try pushing the high beam lever forward. In some cars pulling this towards the driver only "flashes" the high beams, like for warning another driver. To make the high beams remain on usually requires the lever to be pushed forward. Either that or you have a defective switch in the turn lever that needs to be replaced.
Take your car in to have it checked. Turn signals should work without high beams.
Should be like any other vehicle. (pull turn signal stick back (high beams on), pull it back again (high beams off).
Pull back on the turn signal lever to change from high beams to low beams If the turn signal lever is pushed forward the high beams stay on and if the turn signal lever is pulled back all the way that is the " flash to pass " feature
It's possible that when you turn your blinker on you are inadvertently pushing the lever forward causing your high beams to come on and stay on.
high beams!
they had to use ropes