It is either a T-40 or a T-45 Torx.
Jack up front end of car, remove tires. Next unbolt the caliper, which is held on by 2 bolts. Slide the caliper off. The brakes are accessable after the caliper is removed. There is one brake pad on each side of the brake disk. The brake pads sit in a carrier or anchor that holds them in position.
To replace brake pads and rotor: Unbolt wheel, unbolt caliper, remove caliper, unbolt caliper bracket, remove rotor, replace rotor, bolt up bracket, compress caliper, replace pads, replace caliper, bolt up caliper, bolt up wheel, repeat whole thing on other side...
7mm Allen
To replace the front brakes on a Volvo S60, begin by safely lifting the vehicle and removing the front wheels. Next, detach the caliper by removing the caliper bolts, then slide off the caliper and support it (do not let it hang on the brake line). Remove the old brake pads from the caliper bracket, replace them with new ones, and compress the caliper piston if necessary. Finally, reassemble the caliper, reinstall the wheel, and lower the vehicle before testing the brakes.
# Raise and support truck on jackstands and remove tire # Remove the brake caliper.After removing the caliper bolts suspend the caliper out of the way with a piece of wire.On front disc brakes remove the 2 caliper mounting bracket to steering knuckle bolts and detach the mounting bracket.On rear disc brakes the rotor can be removed after the caliper has been removed
if your looking for the front abs sensors thay are located in the hubs, and would have to remove front tire, brakes,caliper, and rotor to remove.
You will need to remove the tire and wheel from your 1986 Honda Accord. Remove the brake caliper and the brake spring. The disk brakes will come off. Reverse the process to install the new front disc brakes.
This is how you will replace the front brakes on a 2000 Saturn Sc first you will jack the car up with jack stands. You will then remove the front wheels, next remove the upper caliper to mount bolt only. Then you will pivot the caliper downward to access the pads, you will remove the old pads and install the new pads. You will use a 'C' clamp and a old pad to bottom the caliper piston and you will pivot the caliper back into place and re-install the bolt.
I just did my 2005 Ford Escape front brakes and the caliper was 7mm Allen and main holder is 18mm ...RRR Wis.
Remove the tire and wheel from your 1998 Chevy Astro Van. Remove the brake spring and caliper. The brake pads will come off. Reverse the process to install the new front brakes.
It takes a T55 Torx bit on the front calipers.
what is the best way to bleed brakes when installing new caliper on front left wheel