Assuming this is an automatic transmission, pull the dipstick out and read it, it will tell you the proper ATF to use.
dexron
It is in the bottom of the transmission. You will have to remove transmission pan and you will see it.
No, You must remove the transmission pan to drain the fluid.
if the tranny is completely empty of fluid about 12-13 quarts
NO. You must drain it out to the correct level. To much fluid will damage the transmission before it pushes the fluid out of the vent tube.
Assuming it is automatic, read the dipstick, probably Dextron III.
Automatic? Read the information on the transmission dip stick, it will tell you what type of fluid to use. Standard? Use Mercon.
To replace the transmission in a 1996 Chevy truck, start by disconnecting the battery and draining the transmission fluid. Remove the driveshaft, exhaust, and any components obstructing access to the transmission, including the crossmember and starter. Unbolt the transmission from the engine and carefully lower it using a transmission jack. Install the new transmission by reversing the removal steps, ensuring all connections are secure and refilling the transmission fluid.
For a 1998 Dodge truck, the recommended transmission fluid is typically ATF+4, which is a synthetic automatic transmission fluid. It's essential to check the owner's manual for specific recommendations based on the model and engine type. Always ensure that the fluid meets the required specifications for optimal performance and longevity of the transmission.
any run of the mill PS fluid can be used in a Chevy truck/SUV. in a pinch u may sub in ATF (Automatic Transmission Fluid.)
While the truck is running in idle pull out the dip stick and read it.
where is the transmission censor located on a 1997 Chevy cheyenne truck