lava lamp
To separate paraffin wax from tar, you can use a method involving solvent extraction. First, heat the mixture to melt the paraffin wax, then add a non-polar solvent, such as hexane, which dissolves the wax but not the tar. After mixing, allow the mixture to cool, then filter to separate the solid tar from the solvent-wax solution. Finally, evaporate the solvent to recover the paraffin wax.
First off do not use tap water. Use only distilled water. You will need to add 3 gallons of distilled water to the solution to get 60% antifreeze and 40% distilled water or a 60/40 mix.
Petrol and paraffin can be separated using fractional distillation, a process that takes advantage of their different boiling points. Petrol has a lower boiling point than paraffin, so when heated, petrol vaporizes first and can be collected separately from paraffin.
1859
To flush antifreeze from a swimming pool, first ensure that the pool's water level is lowered to below the skimmer and return jets. Then, use a submersible pump to remove the antifreeze solution, directing it to a suitable drainage area. After pumping out the antifreeze, refill the pool with fresh water and run the filtration system to help clear any remaining traces. Finally, test the water chemistry and adjust as necessary before using the pool.
1929
Check with ford dealer or you can buy antifreeze that mixes w/ any types of antifreeze - but check first or you can cause problems
they started using antifreeze in cars in 1324 march.20 on tuesday
Paraffin wax was first created by Carl Reichenbach in Germany in the early 19th century. He discovered it as a byproduct of distilled wood tar and named it "paraffin" from Latin words meaning "lacking affinity."
Prestone extended life diesel antifreeze(red) sold at tractor supply.4 jugs antifreeze + 4 jugs distilled water(sold at the grocery store).flush the cooling system out first(get all the old coolant out first)
To stain clubroot spores, you can use a methylene blue or lactophenol cotton blue solution. First, prepare a fresh sample by suspending the spores in a small amount of distilled water. Then, add a drop of the staining solution to the sample and mix gently. Allow the sample to sit for a few minutes before observing it under a microscope, where the spores will appear more distinct and easier to identify.
Yes, if your vehicle is low on antifreeze, there may not be enough to fill the heater core, and you wont get any heat. When the heat stops working in your car, antifreeze/coolant should be the first thing you check.