0
What would cause the daytime running lights and the drivers side hi-beam to not work on a 98 Chevy Cavalier?
Check the wiring and socket to the high beam light. Mine was bad on a 96 and after replacing it mine worked.
did you ever figure out what was the matter with the car....? curious....as i have a 2000 that the daytimes go out on ...and do not have any high beams.....thanks
My did the same, you have to replace the regular light bulb on the drivers side, it should work after that. Is your service light (on your dashboard) on?
What else can I help you with?
On a 2002 Trailblazer headlights don't work only Hibeam. Is it the headlight sensor or the switch assembly?
I have changed the driver's side bulb and checked all of the fuses,now the passenger side stays on hibeam only, nothing seems to work. And now the truck will not enguage into gear at all? any advice?
What is wrong with a Ford Focus rear turn signal that won't flash but only stays illuminated?
the bulb is probably blown there like a headlight bulb low beam hibeam so if its blown it will just be illuminated and not flash
How do you replace the HiBeam in a 1987 Jaguar Vanden Plas?
you start by removing the chromed Ring which is held in place by 1 screw at the top center; then you remove the Inner screws which hold the black ring to the headlamp Bucket, which holds the headlamp in place; WARNING: do not confuse these screws with the headlight Aim Adjustment screws which you can identify by a white plastic spacer and Spring behind them. do not touch those. Once the black ring is loosened and removed, the headlamp will tend to fall off, so keep your hand in front of the glass lamp. Pull the glass headlamp out from the Bucket, then disconnect the Electrical Plug from the rear of the headlamp, get the new replacement, re-connect the Plg to it, then reassemble both rings in reverse. this applies to all 4 headlamps. Same procedure and warnings apply.
