answersLogoWhite

0

I would suspect a leaking brake booster. When you apply the brakes, the extra vacuum needed, causes the engine to stall. Check the brake booster vacuum line and the booster itself. You also might want to replace all vacuum lines if the car is over 10 years old.

User Avatar

Wiki User

19y ago

What else can I help you with?

Related Questions

Just changed your front and rear brakes and shoes. The brake light turns on until you put in more brake fluid. The brakes feel if they were almost touching the floor at times. What could cause this?

If you are losing fluid and the pedal is low, you have a brake fluid leak.


Does rain cause your brakes to squeak?

No, rain does not cause brakes to squeak. Brake squeaking is typically caused by worn brake pads or a lack of lubrication on the brake components.


What would cause the brake light to come on intermittenly after all brakes were changed?

Check the brake fluid level in the reservoir there is a sensor there that will make the light come on if your level is low.


Your truck makes a hissing sound when your brakes are engaged and your brake peddle travels all the way to the floor before stopping the truck also stalls when brakes are engages?

This one is easy. Brake booster diaphragm is ruptured, causing a massive vacuum leak, which will cause the engine to run poorly when the brakes are applied. A loss vacuum assist will make it difficult to stop the vehicle.


Sticking brake caliper?

If the front brake caliper is sticking, the disc may be uneven. Brakes that are left to scrape on the disc for a long time before they are changed will damage the disc enough to cause sticking or slipping.


Front brake caliper sticking?

If the front brake caliper is sticking, the disc may be uneven. Brakes that are left to scrape on the disc for a long time before they are changed will damage the disc enough to cause sticking or slipping.


What brake pedal is the cause of air being in the brake system?

The brake pedal has nothing to do with it. If air is in the system then bleed the brakes.


How can I effectively use WD40 for brakes maintenance?

It is not recommended to use WD40 on brakes as it can cause the brakes to become less effective. It is best to use brake cleaner specifically designed for brake maintenance.


What is the MAIN cause for brake fade?

a wild panda tampering with your brakes


What could cause one of your rear drum brakes to brake more sharply than the other one you already replaced the brake pistons and bleeded the system?

un equal adjustment of brakes will cause one brake to apply earlier and harder than other brake


What would cause brakes on 2007 ford escape to grab the fluid is full and brakes are good?

Sticking caliber. Flush the brake system and install fresh brake fluid, then bleed the brakes. If that does not help, replace both calibers and brake pads on the axle where the brakes are grabbing.


What can make the brakes grab in reverse?

warped brake discs can cause your brakes to grab in reverse. Hope this helps.