Yes, this is an interference engine and if the belt breaks you will have engine damage. The belt must be changed every 105,000 miles.
The single overhead cam 2.0 sohc usually bends valves. The 2.0 dohc, dual overhead cam, is usually ok.
On a 1998 Nissan sentra 4 cylinder when the timing belt breaks does it bend the valves
If the timing belt in the 1998 Chrysler Sebring causes damage to the valves and the head when it breaks, they will have to be replaced. It is recommended that the water pump also be replaced when replacing the timing belt.
Yes, if the timing belt breaks on a 1998 Mitsubishi Eclipse, it can cause the engine's valves to bend. This vehicle has an interference engine, meaning that the pistons and valves occupy the same space at different times. When the timing belt fails, the pistons can collide with the open valves, leading to potential damage. It's important to address timing belt replacements at recommended intervals to prevent such issues.
Yes, the valves will most likely be damaged if the timing belt breaks. There is usually further damage associated with the timing belt breaking while the engine is in operation. Some additional damages could be, connecting rods, crankshaft, lifters, and cam damage.
This is a non-interference engine, meaning if the timing belt breaks it will not damage the engine.
( Yes ) according to the Gates website ( they make timing belts etcetera ) the 2.0 liter four cylinder engine in a 1998 Ford Contour IS NOT an interference engine
A 1998 Mercury Mystique with the 4-cylinder 2.0 DOHC appears to have a non-interference engine. Therefore, if the timing belt breaks, there should be no damage to the valves/pistons.
The engine is an interference engine, if the timing belt breaks or slips it will cause damage to the valves and possibly the pistons.
Worst case scenario, the pistons will slap the valves wrecking them and possibly even scaring the piston heads as well. Could be very costly so replace your timing belt at regular intervals to avoid this.
No
Yes. If the timing is off, the pistons will damage the valves