If the hood don't come the the lock like the metal piece to lock it in. or carbon fiber hoods.
On the Hood
To install hood pins on a 1972 Barracuda, first, determine the desired location for the pins, typically near the front corners of the hood for proper support. Use a drill to create holes for the pins, ensuring they align with the corresponding holes in the hood latch mechanism. Secure the pins with nuts and washers from underneath the hood for stability. Finally, test the pins to ensure they hold the hood securely while allowing it to open and close smoothly.
You will need to go under the hood first to remove the gas tank. Then you will need to go under the deck and remove 2 pins that are near the cables. After you remove those pins, there are some clips that need to be removed and a couple of ties. You then can remove the cables to replace them.
Open the hood and locate L-shaped pins at the corners of the headlights.Unlock pins by turning a quarter turn and pull pins upward.Headlight assembly can then be removed and bulbs replaced.
open hood two pins with rubber caps hold lights in. pull them up and out light will then fall out change bulbs and reinstert pins
PINS stands for Person In Need of Supervision
No. If it does, you need new security pins.
no
use sellotape or wee on the edges and place gently down or just leave the hood off and let the wind ripple thru your greasy and nit infested hair
You can make pins by using a pin machine. All you need is a magazine or something to have pictures from and some pins with just plastic!
No - http://www.nastyz28.com/camaro/camaro70.php - Middle / Bottom of page lists available options - hood pins aren't listed. Doesn't mean they may not have been a dealer installed item - but I doubt it.
No but you need the right one - one has flat pins - one has round pins check your plug end