0
When hooking up a battery to a car battery to jump start it which cable should one attach first?
1. connect red booster cable to weak battery POSITIVE post. 2. connect red cable to POSITIVE post on booster battery. 3.connect black cable to booster battery NEGATIVE post. 4.make final connection on engine block of stalled vehicle away from the battery. STAND BACK,start vehicle and remove cables in reverse order of connection by disconnecting engine block connection first.
What else can I help you with?
When hooking up battery which cable first?
Always the negative.
How do you change battery in 2004 gmc sierra?
1. Remove negative battery cable 2. remove positive battery cable 3. remove battery 4. install new battery 5.attach positive cable 6.attach negative cable
Which color do you attach first, red or black?
When connecting jumper cables to a car battery, attach the red cable first before the black cable.
How do you reset the Engine light on a 1996 LHS Chrysler?
un-hook the negative battery cable from the battery for 15 minutes and then re-attach cable.
How do you hook up jumper cables from one care to another?
To hook up jumper cables, attach one cable from the negative post on one battery to the negative post on the other battery. (These usually are marked "-" and have a blacl cable attached to them.) Attach the other jumper cable from the positive post on one battery to the positive post on the other battery. (These usually are marked "+" and have a red cable attached to them.)
How do you reset computer on a 1999 suburban?
That is correct, but you should leave it off for some time in order for it to reset. Disconnect red battery cable from post then re-attach.
When charging a battery, should you use a red or black cable first?
When charging a battery, you should always connect the red cable first before the black cable.
How do you install a starter on a 1997 Toyota Corolla 1.8L?
Remove the positive battery cable from your 1997 Toyota Corolla battery. Tighten the starter with the retaining bolts. Attach the cables to the front of the starter. Reattach the positive cable to the battery.
How do you get into the boot of a bmw 850 with a dead battery and no key?
If all else fails you can jack the vehicle up, support it on a jack-stand, and attach a red jumper cable to the starter positive red cable where it connects to the starter and then attach black cable to any metal place on the engine. You can use this procedure to charge the battery with either a battery charger for jumper cables from a donor vehicle.
How do you charge a motorcycle battery with a car battery?
You must get a couple of so-called jumper cables. The cables have strong clamps on them and are designed to be clamped to the battery terminals. Attach the black cable to the negative terminals of the motorcycle and car battery first. Then attach the red or positive cable to the positive terminals of the motorcycle and the car battery. In case your motorcycle battery is empty, you can now start the bike from the car battery. Disconnect the cables in reverse order, beginning with the red cable. The motorcycle battery will not be charged much by the car battery but the bike can be jump started by using this method.
What type of network cable should be used to attach to an existing one?
an RG-6 Cable should be used. Trolled
How do you charge a battery in a Pontiac Montana?
where can i attach the negative of my cable to jumpstart my battery for 1997 Montana van. Attach the negative cable to any bare metal within the engine itself, be sure to keep the cable clear of any belts or moving parts. There is a bolt in the middle of the engine that I used last week to perform the task.
