0
What else can I help you with?
How do you do a radiator flush on a 1995 Saturn?
The radiator on a 1995 Saturn is flushed by draining the coolant, refilling the engine with water, and adding a flush. It is allowed to circulate and drain before refilling with coolant.
Do you unplug before measuring resistance?
Yes. Measuring resistance involves imposing a small current through a device and measuring the voltage drop. If there were any other source of voltage, the reading would be in error. You could also damage the ohmmeter if there were an external voltage source. You should also take the device out of circuit before measuring it, so as to not bias the results by the resistance of other devices in the circuit. It all depends on the situation, for which you are responsible for evaluating before you start.
What kind of coolant do you use in a 2001 Yamaha Kodiak 400?
If coolant needs to be added and the owner does not know what kind is already in the engine, it should be drained and flushed before adding any new. Most coolants are appropriate, but it is not recommended to mix brands or types. Use a coolant safe for aluminum blocks or buy Yamaha brand coolant specifically for your model. The coolant should be premixed 50/50 or if it is not premixed, mix it 60% coolant and 40% water before adding.
In the unknown of measuring the voltage what should be the setting of VOM selector?
Use the highest available voltage setting. One should know the system voltage before attempting to measure, other wise it may lead to accidents.
What type of coolant for 91 Buick reatta?
For a 1991 Buick Reatta, the recommended coolant is a 50/50 mix of ethylene glycol-based antifreeze and distilled water. It's important to use a coolant that meets GM specifications, such as Dex-Cool or a conventional green antifreeze, depending on your preference. Always check the owner's manual for specific recommendations and ensure the cooling system is properly flushed before adding new coolant.
If you make a mistake in polarity when measuring the value of dc voltage in a circuit with a digital vom what will happen?
With a "Fluke" it still reads the correct voltage but with a "minus" sign before the figures. HOWEVER do not do this with an oldfashioned moving coil meter, it will blow up literally!
Where is the radiator drain plug located on a 1998 Chevy Prizm?
It's on the bottom of the radiator, and there's also a coolant drain plug somewhere on the block, but I've never flushed the coolant on mine, so I don't know exactly where. Don't forget to let the engine cool COMPLETELY before you do this. It's not just a matter of you getting burnt, you could also damage the engine if you drain the coolant or oil while its hot.
Your 2000 Chevy cavalier was flushed out and new antifreeze put in and now it is over heating and did not do that before what can you do?
It most likely has an air bubble. Allow engine to cool completely. Find bleeder valve and open to remove air bubble. This may require adding coolant. Close valve when coolant comes out. Fill reservour to correct level and go for a spin.
Can you use the same measuring cup when measuring ingredients for pastry?
Yes, but you should measure solids before measuring liquids. If you, for example, measure water before measuring flour, the flour will stick to the measuring cup.
Why might the unloaded output voltage of a transformer be higher than its rms of 12.6v?
Because the windings of transformers have resistance, the primary and secondary currents will cause voltage drops. To compensate for the drops, the transformer may have been designed to have a higher than specified output voltage when there is little or no output current. The no load output voltage typically is only slightly greater than the specified voltage. Before measuring the output voltage, measure the input (line) voltage. If it is not as specified for the transformer, calculate its effect on the output.
Does my 98 Saturn SL 1.9 take the green coolant or the orange coolant also i have what looks like MUD in my resavoir need flush?
The universal coolant is a good way to go if you are not sure which it takes. The 98 Saturn has a big colored dot on the reservoir, green or orange Here's my opinion. They make a universal coolant now, perhaps Prestone or some other brand. It claims it can be mixed with ANY type of coolant... if you're not sure what it takes, go with that. Take your time flushing your coolant if it looks like mud. You may have to flush it multiple times to get all the junk out. I bought my Saturn used. When I checked all the fluids my coolant was a browish color. I ask my mechanic he told me that who had it before put both green and orange coolant in it. He flushed it and put in orange coolant.
Is measuring ohms important to have the circuit switched on?
Measuring ohms, or resistance, is typically done with the circuit switched off to avoid damaging the multimeter and to ensure accurate readings. When the circuit is energized, the presence of voltage can affect the resistance measurement and may lead to incorrect values. Therefore, it's essential to turn off power before measuring resistance to get reliable results.
