When your master cylinder is low you either have a leak or your brake pads are worn. Inspect the system for a leak and inspect your pads before adding fluid. If all is well add fluid when it is at the add mark on the master cylinder. Use only the approved fluid listed on the master cylinder. Normally DOT3.
shut off you e-break or add break fluid it will shut off i prommis shut off you e-break or add break fluid it will shut off i prommis
In the break reservoir i believe
You should not have to unless you have a leak
clutch master cylinder right next to brake fluid, the smaller one
You should always change the transmission fluid according to the vehicle manufacturer's recommendations. However, it is perfectly fine to add fluid as needed between changes.
It does not make a difference if the car is hot or cold when you add brake fluid.
You should never add transmission fluid to a Chevrolet 350 engine. You can add transmission fluid to the transmission through the transmission dipstick holder.
Unless you have a LEAK you shouldn't have to add automatic transmission fluid on a regular basis
When the level gets to the add mark. Usually the add mark will require 1 pint of fluid. Never ever overfill the transmission with fluid. Check the level according to instructions in your owners manual. If you have to add fluid, then you have a leak.
Hydraulic fluid should be poured in the oil tank.
break lining break pads break shoes break pipes break fluid leakes brake disk
Should be next to the brake fluid cup. DJ FLIP Housepartykings.com