0
What else can I help you with?
When towing another vehicle with a chain or cable the flag which is attached to the chain or cable must be what color?
I do believe it is not legal any longer to tow with a chain or cable, but in the Driver's handbook it states that if you do it must be WHITE and no less than 12 Inches squared.
To a sailor what is a hawser?
That would a thick cable or line that is used for mooring a ship or towing another ship.
What should I do if my shifter cable broke while driving?
If your shifter cable breaks while driving, safely pull over to the side of the road and turn off your vehicle. Do not attempt to drive with a broken shifter cable as it can be dangerous. Contact a professional mechanic or towing service to have your vehicle towed to a repair shop for the necessary repairs.
What should I do if my gear shift cable broke?
If your gear shift cable breaks, you should immediately pull over to a safe location and turn off your vehicle. Do not attempt to drive with a broken gear shift cable as it can be dangerous. Contact a professional mechanic or towing service to have the cable repaired or replaced.
Where does the negative cable from battery go to on 300zx?
The negative cable is attached to ground. On some cars is attached to the frame and on some it is attached to the engine.
What is the name of the device that should be attached at the end of a cable in a cable topology?
its called a cable
What does the cable grip do in a plug?
A cable grip is a device for propelling a vehicle by attaching to a wire cable (also called wire rope) running at a (relatively) constant speed. The vehicle may be suspended from the cable, as in the case of aerial lifts such as a gondola lift may be guided by rails, as in a cable traction railway, or may be self-guiding, as in a button lift. Typically, multiple vehicles will use the same cable; where just one or two vehicles are in use they will tend to be attached to the cable permanently.
What does a cable grip do in a plug?
A cable grip is a device for propelling a vehicle by attaching to a wire cable (also called wire rope) running at a (relatively) constant speed. The vehicle may be suspended from the cable, as in the case of aerial lifts such as a gondola lift may be guided by rails, as in a cable traction railway, or may be self-guiding, as in a button lift. Typically, multiple vehicles will use the same cable; where just one or two vehicles are in use they will tend to be attached to the cable permanently.
How do you remove the front parking brake cable for 88 Toyota?
There is an intermediate lever in the undercarriage of your vehicle. The front cable is attached to the lever with a pin, secured with a cotter pin. Find that and pull the pins to release the cable anchor. Follow the cable housing toward the front of the vehicle. Remove the anchor strap holding the cable housing to the body, and open the clamp holding the housing to the body further up toward the engine. On the firewall of your vehicle there is a pulley housing. Its located to the inside of the brake master cylinder. Unbolt the housing, and the front cable should be anchored to the stem right at the firewall. Just slide the anchor stud out, and the entire front cable should be free to remove from the vehicle.
WhAT is the speedometer cable attached to?
It depends on the manufacturer. Most rear wheel drive vehicle speedometer cables connect to a gear in the transmission "tailshaft". Front wheel drive vehicles may connect at another location on the transaxle or they may use an electronic Vehicle Speed Sensor (VSS) that sends a digital signal to the speedometer, in which case there is no speedometer cable. Other vehicles, such as the old VW Beetle, used a speedometer cable that connected directly to the front wheel. Unfortunately, there is no way to list what method was used by all vehicles.
How do you hook up jumper cables from one care to another?
To hook up jumper cables, attach one cable from the negative post on one battery to the negative post on the other battery. (These usually are marked "-" and have a blacl cable attached to them.) Attach the other jumper cable from the positive post on one battery to the positive post on the other battery. (These usually are marked "+" and have a red cable attached to them.)
What is a cable box?
A cable box is a device attached to a set top box connecting a house to a cable service.
