answersLogoWhite

0

You must dim your high beam lights when approaching oncoming traffic within 500 feet or when following another vehicle closely, typically within 300 feet. This is to prevent blinding other drivers and ensure safe visibility for everyone on the road. Additionally, you should switch to low beams in well-lit urban areas or when driving in fog, rain, or snow, as high beams can create glare in such conditions.

User Avatar

AnswerBot

6d ago

What else can I help you with?

Related Questions

How many meters must you dim your high beam lights within any vehicle you are following?

100 metres?


What causes the hi beam lights to be on dim when the low low beam lights are on?

Check the grounds for the headlights.


How Dim lights on 1994 Corvette?

PULL THE TURN SIGNAL LEVER TOWARD THE DRIVER. THAT CHANGES FROM LOW TO HIGH BEAM


Why are your head lights dim but high beam ok?

i just had that same problem on my 106 found it to be the relay that was causing the problem!


Within how many feet must you dim your bright headlights?

use low beam lights within 300ft of on coming vehicles


When you approach a car using there high-beam lights you should?

When approaching a car using high-beam lights, you should dim your headlights to low beam to avoid blinding the oncoming driver. This is not only courteous but also a traffic safety regulation in many areas. If the other vehicle does not dim their lights, maintain your focus on the road ahead to avoid glare. Always be aware of your surroundings and adjust your speed accordingly.


Are the dim lights the inner or outer on a74 corvette?

The low beam lights should be set up as the outermost headlamps. All 4 will be on the when the "high beams" are switched on


Where are the dim lights located on a 2001 Subaru Forester L when we dim our lights the head lights go off and the fog lights stay on are those the dim lights as well any info would help?

The 2001 Subaru Forester has dual beam (both low and high beam are produced from the same bulb) so the low beams are in the exact same place as the high beams. Normally if your fogs are switched on and you're in low-beam mode, you should have fogs and low-beams. When you switch to high-beam, its just high-beams (fogs turn off normally). Both bulbs could be burnt out, but most likely its a fuse issue. See sources and related links below for more information on bulbs.


What are high beams on the car?

High beams are the "bright" setting of your headlights. The reason they are sometimes referred to as "high beams" is because when they are on high beam or bright setting, the lights are directed straight out, instead of a bit more downwards as they are on "low beam" or "dim".


Car headlights must be used from?

You can put your dim lights on as soon as it gets a little bit dark, when it gets darker you can change to full beam.


Why does daytime running lights not work and right headlight is dim on low or high beam on 2002 cavalier?

Sounds like it might be a bad ground


How can you bypass the fog lights on a 2004 Jeep Liberty so when you change to high beams the fog lights stay on?

You could wire them with the running lights instead of the bright and dim. Otherwise you will have to install a toggle switch to override turning off fog lights when using running lights only. It is against the law to run your fog logs in the high beam mode, you may only use fog lights while in the low beam mode. Not that that matters to most people, but in high beam they will not provide any usable light anyway, or is it you just think it looks cool to have them on even in the high beam mode?