0
What else can I help you with?
You replaced brake switch lights still on?
Check the petal and make sure that the plastic part that touches the brake light switch when the petal is in contact with the brake light switch is still on the petal, if it is missing you will need to replace it, so the petal will make correct contact with the brake light switch.
You jus changed your brakes and bleed it why is your brake petal still soft on your 93 Honda delsol?
There is still air in the system.
The parking brake pedal on my 2001 dodge ram 1500 is stuck to the floor. How do I fix it.?
If the parking brake pedal on your 2001 Dodge Ram 1500 is stuck to the floor, you might have broken the parking brake cable. Remove the rear tires to see if the cable is still attached and replace it as needed.
What to check if brake lights have new bulbs and fuses and still do not work on a 2002 jeep liberty?
brake light switch, may be located above the brake pedal where it mounts under the dash, did you find any parts laying on the floor ? No I did not
When we bleed the brakes with the car turned off turned off the brakes seem good As soon as you start the car and the power assist kicks in the brake pedal goes right to the floor Help?
Brake Pedal Goes to the Floor After BleedingAlthough there could be more than one reason, I suspect that even though you may have bled the brake system, AND the brake fluid reservoir is full, your brake bleeding was not successful, and you STILL HAVE AIR IN THE BRAKE LINES, or in the wheel brake slave cylinders.
Having brake problems on a 95 ford ranger xlt 2.3l v6 you replaced master cylinder brake booster bled the brakes pedal still goes to the floor?
You need to bleed the brakes.
How do you clear ABS codes on a 98 Malibu I fixed problem and light still comes on I unplugged battery and light is still on how do you get it to go out?
My 1998 Malibu had the same problem. The reason that it is on is because your brake sensor is located in your wheel bearing, and most likely your wheel bearing is worn out. I replaced both front wheel bearings and the ABS light is no longer on.
Where is the emergency brake release located on a 2008 Chevy Malibu?
To release the parking brake, hold the regular brake pedal down with your right foot. Push down momentarily on the parking brake pedal with your left foot until you feel the pedal release. If the parking brake is not released when you began drive, the brake system warning light comes on and s chime sounds as a warning that the parking brake is still on.Manual Book page 2-28
Why does anti theft system affect rear back lights?
Answer to brake light promblemI don't think it should, check your fuse, it should be in the car in the fuse panel, it should be a yellow 15 fuse. try to replace it, if it still don't work, cheak for losse bulbs, wires, brake switch (on the brake petal ) etc...It's more than likely a loose fuse or broken brake switch.
How do you know the master cylinder is bad on 92 Chevy truck?
When you hold pressure on the brake pedal at a stop light and the pedal slowly drops to the floor and the brake fluid reservoir still remains full, the master is bad.
On your '93 ford tempo we've replaced the master cylinder and the brake booster and bled the lines but the brake pedal still goes to the floor?
did you bleed brake master if you did check brake hoses see if they move when pushing pedal down if it has rear brake drums see if wheel cylinders are leaking rear shoes could be out of adjustment
Is a pedal from a flower is plucked is still alive?
The plant will stay alive but the petal will die.
