Airbag connectors under seats are typically located along the wiring harness that runs beneath the seat. They are often found near the seat's base, close to the mounting brackets or on the side of the seat frame. In some vehicles, these connectors may be secured with clips or covers to prevent accidental disconnection. It's important to handle them carefully during maintenance to avoid triggering the airbag system unintentionally.
under the center console between the drier and passenger seats
Under the center console, between the front seats.
at passenger side in the smart box under the passenger's airbag.
To disable the airbag system in a 2010 Dodge Challenger, you can disconnect the battery and wait for at least 10 minutes to ensure that the system resets. Then, locate the airbag fuse in the fuse box and remove it. Alternatively, you can also disconnect the airbag connectors under the driver's and passenger's seats, but this should only be done by a professional due to safety concerns. It's important to note that disabling the airbag system can be illegal and unsafe, so it should be approached with caution.
Unplug the yellow connectors under the drivers seat and spray both sides with contact spray. Reconnect and problem should be solved. If not, try the same thing on the passenger side. If that doesn't work, repeat process on botgh seats.
the airbag module is located under the center console, between the seats under the carpet. the wiring comes out the back and under the drivers seat. if you want to cut the carpet instead of removing both seats, start at the hump and cut towards the front so you don't cut the wires.
To disable the airbag light on a Toyota Paseo, you typically need to address the underlying issue that triggered the light, such as a fault in the airbag system. This may involve checking and reconnecting any loose wires or connectors under the seats or dashboard. If the problem persists, using an OBD-II scanner to read and clear the trouble codes can help reset the light. However, it's important to ensure that the airbag system is functioning properly for safety reasons before attempting to disable the light.
some times it the wires under the seats that make the air bag light stay one just reach under the seats and wiggle the wires till the light goes out simple as that
The airbag module (little black box) is located between the front seats under the arn rest. Two or three screws to take the plastic middle cover off and you got it.
All children 12 and under should remain in the back seat. Children 12 and under can be killed by the airbag in the front seats.
Airbag system fault or air bag / seat pretensioner fired. If both the seat belt and air bag warning lights are on it could be that one of the plugs under the front seats has come away from its socket. Look under the front of the front seats and you'll find the plug and socket.
It is usually bad connections under both seats a common problem usually cured by snipping off the connectors and soldering the wires together make sure you connect the correct wires together ,.Make sure you disconnect the battery and leave for an hour before starting work or the airbag will detonate when fiddling with the wires.also if its a D8 406 make sure you know your radio code as it will need resetting