0
There is only 2 radiator hoses 1-1/2-2 inch. 1 upper and 1 lower. If ur draining the radiator, most new cars have a pep-cock, little valve that drains the fluid. Lower hose does the same-messier,but faster. If were 2 more smaller hose- do not touch unless repl;acing the radiator-they would be for the transmission cooler- and would contain trans. fluid that would need to be topped off, unless plugged when removed(trans. plugs come in a kit but would only real know the size when u remove it.
What else can I help you with?
Jeep Liberty 2002 radiator fan not working?
how do you chage the fan resistor in a 2002 jeep liberty?
How much does it cost to replace a radiator on jeep liberty?
The cost to replace a radiator on a Jeep liberty is approximately $650. The cost includes $250 for labor. Prices vary from mechanic to mechanic.
Where is 2002 jeep liberty thermostat?
The thermostat on a 2002 Jeep Liberty 3.7L is under the housing where the lower radiator hose attaches to the engine.
Can you put a 2.4 engine in place of a 3.7 engine in a 2003 jeep liberty sport?
No. You would need the transmission, wiring, fuel lines, computers, ac lines, and radiator hoses for a 2.4L.
Where is the Radiator Fan Relay located on a 2004 Jeep Liberty Limited?
The 2004 Jeep Liberty radiator fan relay switch can be found on the back of the fan motor. The relay switch is attached directly to the fan motor.
Is there anything that can leak water at the front of a jeep inline 6 other than the water pump?
Radiator hoses, radiator, thermostat gasket,
Where is the thermostat in a Jeep Liberty 3.7?
It is under the housing where the lower radiator hose ataches.
Where is cylinder 1 located on Jeep liberty 2.8?
Number one is nearest to the radiator.
Where to you put antifreeze in a Jeep Liberty 2004?
The bottle on the firewall with the radiator cap on it is where you add coolant.
Location of thermostat on 03 Jeep Liberty?
Under the housing where the lower radiator hose attaches.
How do you ck the water level of radiator of jeep liberty when the radiator cap is on the overflow bottle on the firewall?
Filling the overflow to the correct level will suffice as the radiator will draw out what it needs.
How do you replace the radiator 1987 Jeep Comanche?
To replace the radiator in a 1987 Jeep Comanche, first, drain the coolant by opening the petcock at the bottom of the radiator. Disconnect the hoses, electrical connectors, and any mounting bolts securing the radiator in place. Remove the old radiator and install the new one, ensuring it aligns properly with the mounts. Reconnect the hoses and electrical connections, then refill the cooling system with new coolant and check for leaks.
