They are above the cylinder. to find them fallow the distributor cap wires to the spark plugs There are no cap wires on the vibe, take the plastic cover off the top of engine. There are 4 coils in center of valve cover, remove them and the plugs are down in the holes where the coils came off.
After looking for the manual, I couldn't find much. However, I did some research for the Vibe and from most comments I see, there are four spark plugs that go into the 2003 Vib.e
The spark plugs on a 2004 Pontiac Vibe are changed by removing the plug cover, disconnecting the spark plug wires, and taking out individual spark plugs using a deep wall socket. New plugs are then set to the proper gap and torqued into place.
NGK Iridium IFR5A
Spark plugs are located beneath the individual cylinder coils - fairly deep through the center of the head, under the cover.
To change the spark plugs on a 2008 Pontiac Vibe, first, ensure the engine is cool and disconnect the battery. Remove the engine cover if necessary, then carefully detach the ignition coil connectors and unscrew the coils to access the spark plugs. Use a spark plug socket and ratchet to remove the old spark plugs, then install the new plugs, tightening them to the manufacturer's specifications. Finally, reattach the ignition coils and connectors, and reconnect the battery.
the vibe uses ac spark plugs and they are rebranded ngk
To change the spark plugs in a 2007 Pontiac Vibe, first, ensure the engine is cool and disconnect the negative battery terminal. Remove the engine cover if necessary, then carefully detach the ignition coil connectors and unscrew the coils to access the spark plugs. Use a spark plug socket and ratchet to remove the old plugs, check the gap on the new plugs, and install them securely. Finally, reattach the ignition coils and connectors, replace the engine cover, and reconnect the battery.
I understand that the gasoline filter on a 2003 Pontiac Vibe is in the fuel tank, and seldom needs replacement
First you remove the plastic engine cover on top of the valve cover. Then you remove the wires from each of the three coils, then you remove the bolt holding each coil and remove coil. Down in that hole is the spark plug, remove with socket and replace.
Gap is .044
No such animal . . . Vibe was released in 2003
The 2004 Pontiac Vibe typically uses NGK part number 7092 or AC Delco part number 41-101. These are iridium spark plugs designed for optimal performance and longevity. It’s important to check the owner’s manual or consult a professional to ensure compatibility with your specific engine variant.