Underneath the plastic cover that has MIVEC written on it.
The 2008 Lancer uses a 4 cylinder engine, therefore it uses 4 spark plugs.
Four.
To change the spark plugs on a 2000 Mitsubishi Lancer, first, ensure the engine is cool and disconnect the negative battery terminal. Remove the ignition coil or spark plug wires to access the spark plugs, then use a spark plug socket and ratchet to unscrew and remove the old plugs. Check the gap on the new spark plugs, install them carefully, and torque them to the manufacturer's specifications. Finally, reconnect the ignition components and the battery terminal.
You need to take off the cover from your engine and then you will see a plastic cover with aprox. 6 screws you need to take out those screws and under that you will see the spark plugs
02 lancer gaplook under the hood of your lancer for the specs, but the gap is .039-.042. With platinum plugs, a spark plug gap isn't necessary.
The spark plug gap on 2004 Mitsubishi Lancer 2.4 engine should be set between .7 and .8 mm. A new spark plug may be purchased for this vehicle at any auto parts retailer.
On the engine head !
No, any platinum plug will do. And with platinum plugs, no gap info is necessary.
Last summer, the cylindars started to misfire on my 2002 lancer. Once the spark plugs were changed, I haven't had any more issues.
Most spark plugs are good up to 100,000 miles, regardless of manufacturer or engine. If one fails to light prematurely and causes a cylinder misfire, it'll cause a CEL.
In a 2006 Mitsubishi Endeavor, the spark plugs are located on the engine, accessible by removing the engine cover and the ignition coils. The Endeavor is equipped with a V6 engine, so there are six spark plugs, one for each cylinder. Each spark plug is situated on the top of the engine, connected to the ignition coil, which needs to be removed to access the plugs for replacement or inspection.
It could be numerous things. From a bad fuel pump, for bad spark plugs.