the timing marks are on the back of your cam sprockets.
On a 2003 Ford F-250 with a 6.0L Power Stroke diesel engine, the timing marks are located on the crankshaft damper and the timing cover. The damper typically has a notch or line that aligns with a corresponding mark on the timing cover. For the 5.4L gas engine, the timing marks can be found on the crankshaft pulley and the timing chain cover. Always consult the vehicle’s service manual for precise locations and specifications.
The timing marks for a Bear Tracker 250 cc ATV are typically found on the engine's flywheel and the stator or case. To locate them, remove the timing inspection cover on the left side of the engine. Align the timing mark on the flywheel with the mark on the case to ensure proper timing alignment. Always consult the service manual for specific details related to your model.
Wiring diagram for a Ninja 250 can be found in repair manuals for the Ninja 250. These types of manual are available at the library and auto parts stores.
check on the alternator. there is a small zero located just before where it tell the spark to fire.
the cam has a timing dot it needs to be stright up. the piston needs to be at top dead center. be careful and not get the timing off a tooth one way or the other. it wont run right if you do.
$250 for a ninja
the mark on the camshaft timing gear needs to line up with the mark on the crankshaft timing gear to ensure the camshaft is in proper time with the crankshaft. Keep in mind that the marks will only line-up every other revolution of the engine due to the crankshaft spinning twice as fast as the camshaft.
Ninja 250.
Connect timing light. remove vacuum line and plug to put engine in base timing. loosen the Distributor hold down, turn the dist. left or right to set it with the timing light. tighten the hold down. replace line. White out makes it easier to see the timing marks. the stock timing is 10 degrees
two = )
yes
faster than a thunder