0
What else can I help you with?
Heater blower motor not working?
the switch, or the blower motor resistor, or blower motor usually it the last two at one time
Blower motor resistor in 2005 trailblazer is melted as is the male wiring harness that plugs into it. Is resistor the only cause of problem and how can I fix the wiring harness or must I buy new one?
The blower motor resistor is the common failure. It comes with the wires attached that plug directly to the blower motor itself. If there is another wiriing harness that is damaged then you will have to buy it too. The resistor failure has been linked as the only cause of the melted wires other than the blower motor itself. The motor can be tested with 12v power to it and it should run on high speed when tested.
How do you replace a blower motor resistor for a 2002 Mitsubishi Lancer?
the blower motor resistor is located behind the blower motor which is located behind the glove box there is clip wires you need to disconnect and then connect the new one.
How do you replace blower motor resistor on 2003 Nissan altima?
One can replace blower motor resistor on 2003 Nissan altima by removing the old using spanners and replacing it with a new one.
1995 Nissan Sentra blower motor resistor installation?
Locate the resistor under the dash attached on the blower motor housing. Disconnect the wire harness connector. Remove the resistor and install a new one.
How many resistors are on a 1996 Chevrolet Impala blower motor?
There is only one blower motor resistor and it is located in the evaporator housing.
Can a 1994 Chevrolet Caprice Classic heater blower motor resistor be tested to see if it needs replacing?
If you have only high speed on the blower motor or you are missing one or more low speeds, chances are the blower motor speed resistor is burned out.
Were is blower resistor on e-350 Ford?
On a 1995 Ford Econoline E350, the resistor is located to the right of the blower motor in the engine compartment. It is the second plug attached to the blower motor wiring harness. It has two screws and a white connector compared to the black one for the blower motor.
What does the heater resistor blower effect on a 99 mercury sable?
A bad heater blower motor resistor would effect one or more blower speeds other than high.
The low speed and second speed blowers doesn't work for the blower motor?
the reason blower does not work on all speeds, is the fan blower motor resistor. The resistor is a 4-5 step series circuit, 1 resistor is added for each reduction in speed. If one burns out then so will all speeds below it. The "high" circuit usually has a separate fuse and bypasses the resistor altogether.
Where is the fan blower resistor on a Sunfire 2000?
take the blower motor out you will see two plugs one for the motor and the other for the resistor two screws hold it in place looks like a motherboard price for new one is about 30.00
Where is the 1997 Grand Prix blower motor resistor?
It's on the passenger side of the car.Behind the glovebox,you will have to take the glovebox off the dash.then you will have to lay on the floor on your back,looking upward by the firewall you will see the blower motor.look behind the blower motor you will see a wire harness conected to the blower motor.Thats the resistor,after you un hook it from the blower motor you will have to take the blower motor out.It's held in by three screws,once you have taken the blower motor out,follow the wire harness that you've taken off the blower motor.you will then see the resistor with much effort its easy to get out,it's held in with two screws,you will only take one screw out to get the resistor out.
