answersLogoWhite

0

Almost no vehicle has a drain plug on the fuel tank.

User Avatar

Wiki User

13y ago

What else can I help you with?

Related Questions

Where is drain plug for coolant on 2005 impala?

It is located (if you face the front of the car) on the bottom right. it will drain straight down to the ground and you have to unscrew it from the back of the radiator. it is covered by the plastic scuff guard and sits right on the radiator frame.


Where is the drain plug on the radiator Nissan Frontier?

(2003 Frontier) From beneath the truck, pull back the leading edge of the rubber splash guard that is below the radiator (it is held in with push pins and 1 Phillips screw). Once this is pulled back you can see the bottom of the radiator. In the center there is a plastic plug with a Phillips head. This is the drain plug. Unscrew it with a screwdriver and the radiator will start to drain.


How do you change tail lights on a 3000gt?

remove the back plastic cover in the hatch and youll see the back of the bulb, unscrew and replace.


Where is the bulb for the clock in a Acura tl 2003?

you have to pull the radio. once you do that remove the plastic panel. Then you will have to unscrew the clock from the plastic panel. There is a white piece on the back which is the bulb.


How do you drain torque converter?

Some torque converters have a drain plug on them. Remove the rubber plug from the bottom of the bell housing. Crank engine a little at a time until the torque converter drain plug can be seen from the bottom. Unscrew the drain plug and drain the fluid. Put the plug back in.


How do you remove the headlights on a dodge spirit?

Unlug the light harness, unscrew the plastic nuts, pull out the headlight. Reinstall new headlight, screw the plastic nuts back on and plug the light harness back into the the headlight housing.


How to replace instrument cluster light bulbs in a 1994 Jetta. Blown fuse is not the problem?

pop off the plastic covers around the headlight switch, unscrew the Phillips head screw, also pop off the plastic on the left of the stereo and unscrew the screw/screws. Unscrew the plastic cover directly behind the steering wheel from the bottom. the plastic piece that is in front of the clusters should pull out now. then pop the clusters out of the holders and all the bulbs are right there on the back.


How do you drain the coolant from the motor on a 1994 Lincoln Continental?

first determine if you car has a coolant cap on the radiator or on a plastic bottle, then remove the cap ( only if the car is cool ), 2nd, the vehicle usually comes with a drain plug on the bottom of the radiator usually on the drivers side, looks like a butterfly plastic twist thing that you have to unscrew to drain the coolant. or you can do the im in a hurry drain in which you take off the cap first and then the lower radiator hose connected to the radiator, this usually has a clamp that you can use a screw driver to unscrew off or a tension clamp to where you have to squeeze them together to remove it. this requires some maneuvering up and down, back and forth to remove but it will come off, DO NOT be close to it as coolant will come pouring out at a fast rate, your gonna get wet regardless, but those r the two ways that you can drain the coolant from your vehicle


How can I replace a shower drain cover?

To replace a shower drain cover, you can typically unscrew the existing cover using a screwdriver or pliers. Then, you can place the new cover over the drain and secure it in place by screwing it back on. Make sure the new cover fits properly and is compatible with your shower drain before installation.


How do you change taillights on a 1999 Grand AM GT?

open the trunk, pull back the liner and unscrew the plastic wingnuts, pull out the taillight and un plug the connector


How do you change oil on a Honda Civic?

you have to get underneath the car and remove the drain bolt on the oil pan which is right under the block. don't unscrew the transmission drain plug! let all the oil drain out, then remove your oil filter. it's on the back of the block between the motor and firewall. replace with a new filter, put the drain plug back in, fill with 4 quarts of new oil and start.


Change oil on crown vic?

Remove the drain plug from the oil pan, and let the oil drain into a pan. Unscrew the filter from the side of the block, you may need a filter wrench to do this. Replace the filter with a new one, and put the drain plug back in. Fill the engine with fresh oil.