Try your local autozone. They should be able to give you a print out. If that fails, try looking in a Haynes repair manual.
belt diagram for a 1996 Geo Prizm
replacing serpentine belt on 2000 chevy prizm need help
how to replace the alternator belt of a mitsubishi montero 2000 ?
The alternator blocks access to it. You need to remove the serpentine belt, then the alternator to get to the thermostat.
The routing diagram for the serpentine belt on a 1998 Chevy Prizm with a 1.8L engine typically shows the belt looping around several pulleys, including the crankshaft pulley, alternator, power steering pump, and the idler pulley. The belt should be routed in a way that ensures proper tension and alignment with the pulleys. For accurate installation, refer to a detailed diagram usually found in the vehicle's service manual or on a label under the hood. Make sure the belt is properly tensioned after installation to avoid slippage.
the belt only goes around the crank pulley and alternator pulley
To replace the alternator belt on a 1994 Geo Prizm, first, disconnect the negative battery terminal for safety. Then, locate the alternator and loosen the adjustment bolt and the tensioner bolt to relieve tension on the belt. Remove the old belt and install the new one, ensuring it follows the correct routing. Finally, adjust the tension on the new belt and tighten the bolts before reconnecting the battery terminal.
it goes on the crank water pump and alternator
Buy a Haynes or Chilton repair manual from a parts store.
Could you be more informative?Which engine is in it?Thanks
IN the Haines manual for that car.
below the alternator. there is a diagram on the engine above the serpentine belt