answersLogoWhite

0

That's easy you can find those in the [http://www.themotorbookstore.com/chevpic.html Repair Manaul You Have].

User Avatar

Wiki User

18y ago

What else can I help you with?

Related Questions

What are torque specs for head gasket and intake manifold for 1999 Pontiac sunfire?

The 1999 Pontiac cylinder head gasket bolt torque specification is 160 pounds. The intake manifold bolt torque specification is 90 pounds.


Intake manifold torque setting for intake manifold?

diferential pressure sensor intake manifold plausibility


What are the intake manifold torque specs on 1997 Oldsmobile bravada?

What are the intake manifold torque specs on 1998 Oldsmobile bravada?"


What are the torque specs to replace a 2003 olds alero intake manifold gasket?

alero intake manifold torque specs


What is the torquing specs for the bolts on a 1999 blazer 43 intake manifold The book gives 132 pounds but this seems too much?

I FOUND THIS AT WWW.AUTOZONE.COM, CLICK ON VEHICLE SPECS . For your 1999 CHEVROLET TRUCK BLAZER 2WD: INTAKE BOLT TORQUE FOOT POUNDS (FINAL TORQUE) TORQUE LOWER MANIFOLD BOLTS TO 27 IN/LBS TORQUE LOWER BOLTS TO 9 FT/LBS TORQUE LOWER BOLTS TO 11 FT/LBS TORQUE UPPER MANIFOLD BOLTS TO 44 IN/LBS TORQUE UPPER MANIFOLD BOLTS TO 7 FT/LBS (TO TORQUE BOLTS & NUTS, START IN CENTER USING CRISSCROSS PATTERN)


What are the torque specifications for 2002 Ford 4.0 SOHC intake manifold?

what are the torque specifications for 2002 ford 4.0 intake manifold


What is the intake manifold torque pattern for a 1977 Chevy Blazer with a 305?

start with center bolts and work your way out in a circular patternaltenating from side to side


Intake manifold bolts torque ford windstar?

2000 3.8 Lower intake manifold (manifold to cylinder head) 1st step is 44 inch pounds, 2nd step is 89 inch pounds. This must be done in sequence.


What are the intake manifold torque specs?

hi


What are the intake manifold torque specs for a 403 ci Oldsmobile engine?

Intake manifold torque specifications for the Olds 403 is listed as 30 ft-lbs.


What is the intake manifold torque specs for the 1998 Ford F-150 xlt?

What are the intake manifold torque specs for a 1998 ford f-150 xlt


What are the intake manifold torque specs for a 1999 Ford Ranger pickup 3.0L V6?

What are the torque specs for 99 ford ranger 3.0L intake manifold?

Trending Questions
Why do I smell oil burning when accelerating on incline on freeway only? Where are the fuses located for the tail lights? 96 dodge neon 4 CLY battery light comes on after 10-20 min driving a test machine at local auto part store said your battery is good it reads about 14.5 v on battery when the light is on? Where is the fuel filter located on 1997 Dodge three quarter ton Ram van? What a dot punch use for? How do you run an electrical wire from the interior of a 1998 Grand Am to the battery posts? How do you need to change cv joint on a Mazda protege? If the back of your car is hanging down a lot lower in the front and it rides real rough in the back feeling every bump in the road what do you do or replace to fix that? The starter was hit with a wrench and turned over for a second now car wont start why? Why is your car making a groaning noise when you make a hard right? How much fist width of slack the seat belt across your chest should have? Where is the brake light switch located under the dash on 1991 Ford F150? What is the expected fuel consumption for a 1995 Vitara? Factory tire size for 1991 Buick regal gran sport? Where is the fuel gauge fuse located on a 2003 ford windstar? What would cause a 1991 Geo Metro to have no power when the battery and connections are good? What is the gear ratio on a 94 Camaro? Where is the 2000 dodge neon's fuel pump? Why would a 2005 Chevy Impala smell like gas when it idles? What is the tapping noise on a 350 Chevy it only makes noise when I am driving and under power not at an idle or when I rev the engine in park I think it could be something with the exhaust or tranny?