You can add brake fluid inside the brake fluid reservoir. The reservoir is located on the driver's side under the micro-filter panel.
Remove the black plastic cover (left side only) that covers the brake booster and brake fluid container, located between the left strut tower and left wiper blade (you will need T-20 screw head).
Master cylinder is leaqking internally, what fluid is leaking and can I add fld. until it is repaired ?
Add more fluids
To add brake fluid to a 2005 BMW 645ci, first, locate the brake fluid reservoir, which is typically found near the back of the engine compartment on the driver's side. Remove the cap, ensuring the area is clean to prevent contaminants from entering the reservoir. Add the appropriate type of brake fluid (usually DOT 4 for BMW vehicles) until it reaches the "MAX" line on the reservoir. Finally, securely replace the cap and check for any signs of leaks or low fluid levels in the future.
To add brake fluid to a BMW X5, first, locate the brake fluid reservoir, which is typically found near the back of the engine bay on the driver's side. The reservoir is usually a translucent plastic container with a cap labeled "brake fluid." Ensure the vehicle is off and cool, then remove the cap and add the appropriate brake fluid type as specified in the owner's manual, taking care not to spill any fluid on the engine or surrounding components. After adding fluid, securely replace the cap.
On a 1998 BMW 528i, the brake fluid reservoir is located on the driver's side of the engine bay, near the back of the engine compartment. It is typically a translucent plastic container with a cap labeled for brake fluid. To check or add brake fluid, make sure the engine is off and allow the engine to cool down before opening the reservoir.
On the driver side of the transmission pan there is a fill plug. The car must be in the air and level. With the car running fluid will run out of the plug hole when it is full. This is no fun without a lift.
You add brake fluid to master cylinder reservoir. This is located on the driver's side of the car mounted on the firewall. On late model BMW 5 series, you cannot see this without first removing the large piece of plastic that covers that area of the engine compartment.
Good question. At the brake fluid resovoir
To refill the brake fluid in a BMW 745Li, first ensure the vehicle is parked on a level surface and the engine is off. Locate the brake fluid reservoir, which is typically found near the back of the engine bay, near the driver's side. Remove the cap and check the fluid level; if it's low, add the appropriate type of brake fluid (usually DOT 4). After refilling, securely replace the cap and check for any leaks before driving.
ADD BRAKE FLUID
You open the hood, find the brake fluid reservoir, take the cap off and add DOT 3 brake fluid up to the full level.