== == Go to the web site www.AutoBooks.com They sell Chilton and Haynes repair manuals by mail order. Be sure to specify your car's make year and model and engine size when you order the book of your choice. You will need a valid Credit Card to order from that site.
How do I change a headlight bulb on a 1998 jeep grand cherokee?
Bulbs? Fuses? Relay? Dimmer switch? Headlight switch?
This is probably a 9004 halogen bulb but to be sure just go to your local parts store and tell them that you need a new headlight bulb for a 1998 Jeep Cherokee.
there is no fuse for the headlights......the bulb may be burned out or the headlight switch may be bad
The 1996 Jeep Cherokee headlight relay switch can be found on the firewall in the engine compartment. The headlight relay switch will be on the drivers side of the firewall.
In a 2004 Jeep Liberty, the dimmer switch is typically located on the headlight switch, which is found on the left side of the steering column. You can adjust the brightness of the dashboard lights by rotating the knob or turning the switch. If your model has a separate dimmer control, it might be a small dial or slider near the headlight controls.
Use a wire tester and check everything from the light switch to the headlight assembly. If there's no voltage at te headlight switch, then trace it all the way to the battery.
Most headlights are not fused they are wired direct thru the headlight switch... Is your switch bad??
The switch should be the same as your headlight switch. If not then you will either need to install your own switch for the running lights or buy a new OEM switch module.
The neutral safety switch is located on the transmission, passengers side.
Autozone.com has a listing for the headlight for a 96 Grand Cherokee, price listed is $95.99 u.s.
To change the headlight switch on a 2004 Jeep Wrangler, first disconnect the battery to ensure safety. Remove the trim panel around the steering column, then locate and unscrew the screws securing the headlight switch. Disconnect the wiring harness from the switch, replace it with the new switch, and reassemble everything in reverse order. Finally, reconnect the battery and test the new switch to ensure it functions properly.