All heaters work pretty much the same.
Air intake is either from inside ( recirculated ) or from outside ( vent )
Most home heaters do not have a vent option, so they are pretty much taking in recirculated air through a filter.
To visually determine if there is enough air flow across a duct mounted electric heater, you should tape a piece of cardboard to it. A small piece that can flutter in the flow of the air. If it moves wildly, there is enough air.
No air flow from the heater duct of an 88 Chevrolet Corvette is often caused by a defective blower motor. A blocked air inlet or defective switch can also cause this issue.
The heater does not blow air because it emits infrared rays that have heat molecules within them, thus releasing heat, not blowing it. A heater does not blow air becasue there is no moving air source within the heater. The heater emits infrered rays that cause heat to slowly flow out of the heater.
Air flows into a convector heater through vents or grilles located near the bottom of the unit. This air is then heated by the heating element inside the convector heater before being released back into the room.
A fan interlock relay can be used to prevent the electric heater from being energized when the fan is not running. This relay will only allow power to the heater when the fan is operating, ensuring that the heater cannot operate independently.
on top of heater housing
The best bet is that the valve that controls the flow of water to the heater core is not functioning, but on some cars it's the flaps that control the air flow through the core.
Your thermostat is most likely bad. It controls the flow of warm water into your heater core which warms your air. Its a common problem in winter and an easy fix.
If there is no fan to pull the air in, fresh air must come into a convector heater from below. It is drawn in because the air heated by the heating element is warmer and therefore lighter than the colder air below it. So the warmer air rises to leave the convector heater from the top.
It does not have a water flow valve in the heater plumbing.It does not have a water flow valve in the heater plumbing.
Air flows through the heater core to warm it up. Assuming the heater core is circulating water from the radiator, the problem is usually with the blend doors. These doors regulate air flow through the heater core and when they break, they usually block the input into the heater core and kill the heat. Check heatertreater.net for diagnostic information and an inexpensive fix.
Of course it affects the air conditioning,,,it also affects the heater. Any time u have a restricted air flow it affects how heater and air conditioning works, for the worse. Engineers have designed the heater/ac system to run on clean air, so therefore your heater/ac systems work faster and better with a clean filter. Not to mention your own physical health by breathing clean air.