Haha in the owners manual?
Or call an auto repair store they should know :)
To remove the speedometer cluster from a 1985 Nissan 200SX, first disconnect the negative battery terminal to prevent electrical issues. Next, remove the dashboard cover and any screws securing the cluster; typically, there will be screws around the perimeter of the cluster. Carefully pull the cluster out from the dashboard, disconnect the wiring harness and any cables attached to it, such as speedometer cables. Once everything is disconnected, the cluster can be fully removed.
There is not a cable for the speedometer. The information is sent to the gauge cluster from the PCM. The PCM controls almost all aspects of the vehicle operation. All of the information on the gauge cluster comes from the PCM.
Town and country vans have never had speedometer cables. The speedometer gets it's signal from the transmission computer.
On the starter if 1 pos cable or midway if you have 2 pos cables & is remote mounted between.
The Mazda tachometer and the speedometer have separate cables. The tachometer cable probably does not work properly. Change the tachometer cable.
pull the dash apart. behind the speedometer you will see the cable. it connects to the transmission.
Remove battery cables, remove the sterring colom covers top and bottom. remove the two screws from the cover and the cover. The speedometer cluster is in view. remove the screws on ether side and flip the cluster over. Then you can replace the bulbs by twisting then out. It helps to note the position of the bad light before you take it apart. Cheers .
Speedometer cables can dry out over time. Remove the cable from the back of the speedometer, and lube the cable with graphite. This should fix the issue.
On a 2002 GMC Envoy, the speedometer cable is typically located at the transmission, where it connects to the speed sensor. The cable then runs up into the dashboard to connect to the speedometer gauge. Some models may use an electronic speed sensor instead of a traditional cable, so it's essential to check the specific configuration for your vehicle. If you're having issues, inspecting the connection at both the transmission and the dashboard is a good starting point.
No. No more speedo cables, they are replaced by electronics.
Disconnect the cables at the 1997 Nissan battery. After following one cable to the other end, disconnect it then pull it out. Feed the new cable in the same way. Connect the non battery end. Do the same for the other cable then connect the cables to the battery.
Chang inf a battery on a Nissan Altima is very easy. You will need to remove the bar that is across the battery and then disconnect the battery cables. After the cables are removed, you will take the old battery out and put the new battery in place.