Take off the drivers side tire and its located on the side of the trans
Where is the crankshaft position sensor located on Audi 2002 Audi TT
couple of inches behind oil filter housing
driver's side tucked in right under the oil filter
Where is the crank shaft sensor located in a Audi a6
It tells the injector to fire at correct time
To replace the crankshaft sensor on a 2004 Audi TT, first disconnect the battery to ensure safety. Locate the crankshaft position sensor, which is typically found near the engine's flywheel or crankshaft pulley. Remove any necessary components for access, then disconnect the electrical connector and unscrew the sensor. Replace it with the new sensor, reassemble any components removed, reconnect the battery, and start the engine to check for proper operation.
where is bank 2 camshaft located audi a6 2.8 1999
On a 2001 Audi TT, the RPM sensor, also known as the crankshaft position sensor, is typically located near the engine's crankshaft. It is mounted on the engine block, often near the transmission bell housing. To access it, you may need to remove some components for better visibility. Always consult the vehicle's service manual for specific details and diagrams.
The temp sensor switch is located on the right side of radiator ,at the bottom.
There isn't one, its wired into the ECM.
The crankshaft positon sensor is wrong. I replaced it on my 2001 A4 fixed the problem.
Trouble code P0347 means: Crankshaft position sensor "A" low input (Bank 2)