answersLogoWhite

0

What else can I help you with?

Related Questions

Where is idle air control valve in Mercury Sable 2003?

The idle air control (IAC) valve in a 2003 Mercury Sable is located on the throttle body, which is typically found on the intake manifold. To access it, you may need to remove any surrounding components or hoses for better visibility. The IAC valve is usually mounted with two screws and has an electrical connector attached to it. Make sure to disconnect the battery before attempting any repairs.


Routing for serpentine belt 2003 Mercury Sable?

routing for serpentine belt 2003 mercury sable


What is the battery group for a 2003 Mercury Sable?

36R


Does a 2003 Mercury Sable have a radiator cap?

On a 2003 Mercury Sable : The thread on cap on the engine coolant reservoir is the 16 PSI pressure cap / radiator cap


Does a 2003 Mercury Sable have a timing belt?

No , in a 2003 Mercury Sable : The 3.0 liter " Vulcan " V6 engine is an overhead valve / pushrod design engine that uses ( 1 timing chain ) The 3.0 liter DOHC " Duratec " engine has ( 2 timing chains , 1 chain to each cylinder head )


What is the gas tank size of 2003 mercury sable?

16.6 galons


Where is expansion device on a 2003 Mercury Sable?

Its in my pants. Hey oh.


Where is CD player on 2003 Mercury Sable?

inside the arm rest


Where is the idle air control valve located on a 2003 mercury mountaineer v8 motor?

The idle air control valve is located on the side of the intake manifold right next to the throttle body


Where is the body control module on a 2003 Mercury sable?

The body control module (BCM) on a 2003 Mercury Sable is typically located under the dashboard on the driver's side. It is often found near the steering column or behind the fuse panel. Accessing it may require removing some panels for better visibility and reach. Always refer to a service manual for specific instructions regarding your vehicle.


Where is the inertia switch located on a 2003 Mercury Sable?

On a 2003 Mercury Sable sedan : The fuel pump inertia switch ( shut off switch ) is in the trunk , on the passenger side of the trunk , behind the trunk liner ( there is an access hole )


What is the towing capacity of a Mercury Sable station wagon?

towing capacity of 2003 merc. sable is #1000 class 1 hitch