0
What else can I help you with?
Where is the location of crank shaft position sensor on a Nissan Pulsar N16 2000 model?
Can you please tell me where the location of the Crank Shaft Position Sensor is on a Nissan Pulsar N16 2000 model?
What is the Gearbox oil capacity Nissan Almera N16?
HiThe capacity is 2.8 to 3.0l trs and the reccommended oil is Nissan branded XZ Gear Oil) this is SAE 75W-80
Nissan Pulsar 2000 model N16 engine turns over tries to fire but will not start is there any common faults the car has 110 000 km?
There was a N16 recall do to with the oxygen sensor. One day the car just refused to start. RACQ arrived and the guy said it was the Oxygen sensor and so it was towed to a dealer and the sensor changed. Was alright after that.
Where is the rear window defogger relay located on a 2002 Nissan Almera?
If U have N16 version (facelift), U can find it next to the left of the pedals (behind a metal sheet) - 2 relays at a consol. In the manual: EL-522, 'B' diagram.
Where does Reggie Yates live?
London n16
Which car is recommended N16 or fb15?
F15
Why does 2003 N16 Nissan Pulsar cut out?
The 2003 N16 Nissan Pulsar may cut out due to several reasons, including fuel delivery issues, such as a clogged fuel filter or failing fuel pump. Electrical problems, like a faulty ignition coil or sensor malfunctions, can also lead to stalling. Additionally, issues with the engine's air intake system or engine control unit (ECU) could contribute to this problem. It's advisable to conduct a thorough diagnostic to pinpoint the exact cause.
Does the Nissan Pulsar n16 have a cam belt or chain?
Nissan n16 engines have a timing chain located behind a cover plate just above the water pump
Does Nissan 2001n16 pulsar have timing belt?
No. Nissan N16 Pulsars have a timing chain. (Source: Owner's manual N16-A section 8-5, camshaft operation).
What is the wheel stud pattern for a Nissan Pulsar n16 2001?
Standard pulsar n16 alloy wheels are 14x6 with a 45+ offset with 4/114.3 stud pattern
How do i Set the base idle on a Nissan Pulsar n16?
To set the base idle on a Nissan Pulsar N16, first ensure the engine is at operating temperature and is in park or neutral. Disconnect the Idle Air Control (IAC) connector to disable the idle control system, then adjust the throttle stop screw until the idle speed reaches the specified RPM, typically around 750-800 RPM. Reconnect the IAC connector and turn off the engine. Finally, restart the engine to confirm that the idle speed is stable.
Where is n16 pulsar fuel filter?
it is in the fuel tank on the fuel pump.
