it is inside the distributor
Yes.Yes.
the crank shaft position sensor should be behind A/C compressor.
Code 11 means no camshaft position sensor signal detected during engine crankingFix : Replace the camshaft sensor
Code 11 means no camshaft position sensor signal detected during engine cranking. Fix : Replace the Camshaft sensor
On a 1994 Nissan Quest, the camshaft position sensor is typically located on the front of the engine, near the timing cover. It is usually positioned near the camshaft or the cylinder head, making it accessible for maintenance. To locate it more precisely, refer to the vehicle’s service manual, as the exact location can vary slightly depending on the engine type.
The interrupter magnet is normally replaced by removing the camshaft gear as the magnet is inserted through the back side of the gear.
On the driver's side, in the timing cover in front of the valve cover, if it's a 3.5L. Please specify if its a 3.3 or 3.5L
Yes, the 1994 Mazda MX-3 Precidia is equipped with a crankshaft position sensor. This sensor is part of the engine management system, helping to monitor the position and rotational speed of the crankshaft. It plays a crucial role in engine timing and performance. If you're experiencing issues related to the crankshaft position, it may be worth checking this sensor.
No, a spacer is not needed when installing a camshaft position sensor on a 1994 Grand Caravan SE with a 3.3 V6 motor. The sensor is designed to fit directly into its designated location without additional spacers. Make sure to follow the manufacturer's specifications and torque settings for proper installation.
remove accelerator cable assembly,two small mm bolts,+one bolt holds camshaft pickup,stuck in top drivers side of head
There is no cam sensor on this particular engine. Only a crank sensor mounted behind the harmonic balancer.