Behind the passenger side head in the top of the bell housing.
if it doesnt have a crankshaft sensor then you have a distributer pick up. Its under your distributer cap.
If the crank sensor is not working, the engine will not run.
The Crank sensor is located on the transmission housing near the top at the back of the engine.
most crank sensors are for engine timing with the cam shaft, the distributor on at least 97' dodge and newer controls fuel timing.
A bad cam or crank sensor can cause a no start, but the engine will still crank or turn over.
12 valve engine: front above the crank pulley 24 valve engine: behind the starter.
GAS ENGINE The sensor is mounted on the bellhousing DIESEL ENGINE Bolted to the left rear side of the engine block
It's on the back of the engine, right side, right where the engine and transmission bolt together.
The sensors that usually go bad in a Dodge truck are the throttle position sensor, the oxygen sensor, engine light sensor and crank sensor. These malfunctions can be fixed on any Dodge dealership.
possibly
Just above the oil filter on the engine block.
Yes, the 1993 Dodge Stealth is equipped with a crankshaft position sensor. This sensor is essential for the engine management system as it provides information about the position and rotational speed of the crankshaft, which is crucial for ignition timing and fuel injection. If the crank sensor fails, it can lead to performance issues or engine starting problems.