Odometer is usually controlled by the speed sensor not a fuse . In most vehicles it is sticking out the side of the transmission
There is not any fuse on any car that will disABLE THE ODOMETER. I
There is not an individual or separate fuse for the odometer
This is related to the IOD fuse located in the fuse box under your hood.
The fuse for the odometer on a 2007 Jeep Liberty is located in the fuse box, which is typically found under the dashboard on the driver's side or in the engine compartment. Specifically, you should check the fuse labeled "IPC" (Instrument Panel Cluster) or "Odometer," depending on the configuration. If the odometer isn't functioning, inspecting and replacing this fuse may resolve the issue. Always consult the owner's manual for the exact fuse location and specifications.
On a 2001 Volvo S40, the fuse for the trip odometer memory is typically located in the fuse box under the dashboard on the driver's side. You may need to consult the owner's manual for the exact fuse number, as it can vary based on the vehicle's configuration. If the trip odometer is not functioning properly, checking this fuse is a good first step.
You can not disable the odometer by pulling a fuse.
How do you replace 2005 Mercedes ml350 odometer fuse?
There is not an individual fuse for the odometer. It is powered by the same fuses that powers the entire cluster.
If there is just one light out, the bulb probably burnt out and needs to be replaced. A single bulb will not have a fuse.
On a 2001 Chrysler Town and Country, the fuse for the speedometer is located in the fuse panel. The panel can be found under the hood next to the battery.
There is no fuse for the odometer. If it is mechanical and not working it most likely had a stripped or broken gear.
Odometer Fuse Box RelationshipThat depends on the type of odometer. For example, a mechanical odometer which is driven by a mechanical cable will NOT have any connection to the fuse box OTHER than for lighting, IF the odometer has a light inside of it.On the other hand, if the odometer is of the digital electronic type, it will, in a remote manner, be connected to a fuse which is usually a fuse designated for the "Instrument Panel." In this case, the digital odometer is usually built into/on the Instrument Panel Printed Circuit Board [PCB], and thus will be connected to the fuse box via the PCB wiring harness.