answersLogoWhite

0

bottom right hand corner of the rad. its a white pvs key like poking out..hard to see but look hard, and have fun taking it off

User Avatar

Wiki User

17y ago

What else can I help you with?

Related Questions

How do you flush a radiator on a 1991 subaru legacy?

To flush the radiator on a 1991 Subaru Legacy, first ensure the engine is cool and remove the radiator cap. Place a drain pan under the radiator and open the drain valve to let the old coolant flow out. After draining, close the valve and fill the radiator with a flushing solution or water, then run the engine for about 10-15 minutes with the heater on to circulate the fluid. Finally, drain the flushing solution, refill with fresh coolant, and check for leaks.


How do you bleed the heater core?

If by "bleed" you mean drain, disconnect the lower of the two hoses (do not confuse with the pipes from the AC evaporator) and drain the coolant into a bucket. If you are flushing the system (which you should if you are changing the coolant anyway), dont bother draining it, most of the coolant will flow out anyway, just do the coolant flush and fill from the radiator.


What does flushing your radiator do to a car?

It flushes out old coolant and particulates which have formed in your cooling system.


How do you get rid of the brown water in your radiator?

If your coolant is brown, this means it has LOTS of rust in it. If this is the case, then you need to flush your cooling system and refill it with fresh coolant. Be sure to drain your engine block as well as your radiator, as MANY people neglect to do this. Without draining your engine block, you are basically just changing half your coolant.


How many valves does a radiator have?

Enough to shag it, spoken from experience ;) The average automotive radiator is actually two radiators in one - the larger section for the engine's coolant and the smaller section for the cooling of transmission fluid with some having a section for the cooling of power steering fluid. The only valve in a radiator is one at the bottom for draining and flushing of the engine coolant; the rest of the radiator's interior tubing is clear and un-restricted. landcranch


Where is the coolant temp sensor on a 97 buick century?

The coolant temp sensor on a 97 Buick Century is on the side of the radiator. It is just below the radiator cap.


Where do you add coolant after draining the radiator for a 2001 BMW 325ci?

In the top of the radiator but be sure you've put all the pipes back on


How do you remove the radiator off a 1998 Lincoln continental?

You would remove it from underneath. There is a cross member which holds the bottom of the radiator and you remove this, after unhooking all the lines (trans coolant and engine coolant) and draining the radiator.


How do you do a radiator flush on a 1995 Saturn?

The radiator on a 1995 Saturn is flushed by draining the coolant, refilling the engine with water, and adding a flush. It is allowed to circulate and drain before refilling with coolant.


How do you put water in the radiator?

You don't, unless you are flushing the system. Use distilled water and add it to the coolant recovery bottle - and it needs to be mixed with coolant.


Why is there mud in your radiator?

Mineral sludge from tap water. A good radiator flushing will help and then use proper coolant to help keep the sludge building up and blocking the radiator.


How do you drain the radiator coolant in 2006 Scion xA?

To drain the radiator coolant in a 2006 Scion xA, first ensure the engine is cool and then locate the radiator drain plug at the bottom of the radiator. Place a container under the radiator to catch the coolant, and open the drain plug to allow the coolant to flow out. After draining, close the plug, refill the radiator with fresh coolant, and check for any leaks. Always dispose of the old coolant properly, as it is toxic.