If its the same as a 97 it is right on top of the engine near the radiator hose that goes into the radiator.
You are wrong, on the 97 that is the CAMSHAFT position sensor on top next to the radiator hose the CRANKSHAFT position sensor is under the car, back of the motor, on the bell housing.
Yes
There is one in each exhaust manifold.
It is the sensor in the transmission that reads the shifter position and transmits it to the transmission computer.
On a 1999 Chrysler LHS, the crankshaft position sensor is typically located near the lower part of the engine, often mounted on the engine block or transmission bell housing. It is positioned close to the crankshaft, allowing it to monitor the position and speed of the crankshaft. To access it, you may need to remove some engine components or protective covers. Always consult the vehicle's repair manual for specific details and guidance.
CHECK CRANK SENSOR FIRST ,GET SCRAP YARD PART TO CHECK CHEAP... CAM SENSOR SECOND ECT...
crank sensor first then cam sensor, junk yard parts cut the cost to check this out...
It is part of the rear window defroster grid.
the crank sensor is located in the transmission bellhousing on the lower passenger side where the trans bolts to the engine almost right above the right axle shaft. one 10 mm bolt holds the sensor in place, this is on the 3.5 liter engine,
A Chrysler LHS does not have a mass airflow sensor.
Where is the thermostat located at on a 1999 lhs
Inside the fuel tank. Tank has to be removed to access.
It is inside the latch itself.