360 V-8 Mopar? It should be on top, in back of engine, just to the drivers side of the distibutor.
Directly behind the carburetor, just to the side of the distributor.
It is on the back of the engine, just to the side of the distributor.
It is on the back of the engine, just to the side of the distributor.
1994 360 1500 is back by the Distributor cap, just to the front of it and on the passenger side
The oil pressure sensor on the 360 V8 is on the top rear of the engine, next to the distributor.
behind the intake close to the fire wall right above the top tranny bell housing bolt
Usually the sending unit (float assembly) in the tank has failed.Usually the sending unit (float assembly) in the tank has failed.
It's been a long time since I've seen one of those, but I believe it's on the lower part of the timing cover, near the oil filter.
On a 1992 Ram Van 250 with a 360 ci engine, the temperature sending unit is typically located on the engine block near the thermostat housing. It's usually found on the driver's side, threaded into the intake manifold or the cylinder head. To access it, you may need to remove any obstructions, such as air intake components or wiring harnesses. Always ensure the engine is cool before attempting to locate or replace the sending unit.
rear of eng,by distribitor,Pass side
The unit of measure used to determine absolute location is degrees and minutes of latitude and longitude. The Earth has 360 degrees at the equator.
stop putting 360 games into ur Wii.