0
What else can I help you with?
What sensor matches code P0500 on a 1999 Ford Ranger?
speed sensor a
Where is the throttle positioning sensor on a 1999 ford ranger with a 3.0?
The 1999 Ford Ranger 3.0 liter engine throttle positioning sensor is located on the cylinder head. The sensor will be near the middle of the cylinder head.
Diagram of speedometer sensor 1999 Ford Ranger pickup?
The 1999 Ford Ranger pickup truck speedometer sensor diagram can be obtained from most Ford dealerships. The speedometer sensor diagram can also be found at most auto-parts stores.
Where is a transmission sensor that may cause the vehicle to skip during acceleration on a 02 Ford Ranger 4.0 liter?
where is a transmission sensor that may cause an 02 ford ranger 4.0 liter to feel as though it may be skipping during acceleration?
Where is the camshaft position sensor located on a 1999 ranger 4.0 v-6?
Where is the camshaft position sensor located on a 1999 ford ranger 4.0 liter engine
Where the acceleration switch on a 1999 ford ranger?
The acceleration switch on a 1999 Ford Ranger is typically part of the throttle position sensor (TPS), which is located on the throttle body. This sensor monitors the position of the throttle and sends the information to the engine control module (ECM) to adjust fuel delivery and ignition timing. If you're looking for a specific "acceleration switch," it may refer to components related to the cruise control system or the accelerator pedal position sensor, which can also be found near the throttle body. Always consult a repair manual or a professional for accurate diagnostics and repairs.
Were would the acceleration switch be on a 1999 ford explore?
on the ford ranger pickup truck, it is under the passenger side dash
Where is the mass air flow sensor on a 1999 ford ranger?
its on the air filter housing
Were is speed sensor on 1999 Ford Ranger manual transmission?
its on the rear axle housing
Where is the speed sensor located at on a 1999 ford ranger 6 cylinder?
rear axle housing
1999 Ford Ranger check engine light is on for code P1309 what is it and how costly to repair?
p1039 for a 1999 ford ranger indicates a camshaft position sensor fault. it could be the sensor, wiring, or the PCM. must be properly diagnosed to determine the real fault.
Where is bank 2 sensor 1 on 1999 Ford Ranger?
Bank 2 is the drivers side of a V6 engine in a Ford Ranger Sensor 1 would be somewhere in the exhaust before the exhaust enters the catalytic converter ( upstream sensor )
