0
What else can I help you with?
Is there a ford 302 big block?
No. The 302 is a small block only. However, the 351, came as a Windsor, or small block, and a Cleveland, which was a big block...
Is a 1993 ford 302 block the same as a 1994 block?
Yes they are the same
Will a 1991 Ford 302 work in a 1987 Ford 300?
yes but you would need different engine mounts for the 302 short block
How do you identify 302 engine block has the number jg 23me 208 45k is it a windsor or Cleveland?
Those numbers do not match any Ford engine. 302 engines were not available in a Windsor or Cleveland, only in a 351.
How do you distinguish which size small block ford you have in your car if it is not the original motor?
Check On The Left Side Of The Block For The Casting Numbers Near The Back Freeze Plug. If It Is A 302 It Will Read One Of These C80E-A , C8TE-B . C9TE-C . D10E-AA. If A Small Block 351+++++++ C90E-B . D2AE-BA . D4AE-AA. D4AE-DA. The 289 I Think Was Last Made In The Late Sixties 68, 69. The 302 Last Made In 81, 82. Checvk These Numbers And See If It Helps. Good Luck answer depending what country you are in they still make 302 blcoks and in usa the 302 was still being made all the way up to 92
Will a 1968 Ford 302 water pump work on a 1977 Ford 302?
Different part numbers , look different in picture , so I would say no
Block numbers for piston firing ford 302?
Ford 302 Firing OrderWindsor (aka small block Ford) cylinders are numbered (looking at engine from the front of the car)4 83 72 61 5Standard 289-302 firing order is 15426378. From the front of the car:3 86 74 51 2For HO (High Output/(K-Code?)) models it is 13726548. From the front of the car:7 8 2 34 51 6Boss may be different?
How many cubic inches is 302 small block bored 030 over?
A ford 302/5.0 will be 306ci if bored .030 (4.030" bore)
What Chevy car had the 302 engine?
I can't recall any Chevy using a 302. It was the classic Ford small block used in early Mustangs. Chevrolet did produce a small block 302 used exclusively in the 1967 - 1969 Camaro Z/28.
Where is the Oil Pressure Sending Unit located on a 1990 Ford F-150 with a 302 motor?
The oil pressure sending unit on a 302 ford is located on the block of the engine. It screws into the block and the sending unit goes on the end. The oil pressure sending unit on a 302 Ford is slightly above and to the left of the oil filter. I find it is easier to replace with the oil filter out.
Where is serial number on 1969 ford 302?
It is on the back of the block between the cylinder heads at the very top where the intake manifold meets the block
Where is the coolant temperature sensor on a 1994 Ford F150?
One the engine block on the 302 and 351's
