Behind the glove box or compartment.
In a 2004 Isuzu Rodeo, the fuse for the AC blower motor is located in the fuse box under the dashboard on the driver's side. You can find the fuse box by removing the cover and looking for the specific fuse labeled for the blower motor. Typically, it is designated as "BLOWER" or similar in the fuse diagram. If the fuse is blown, it should be replaced with one of the same amperage.
The blower motor resistor on a 2001 Isuzu Rodeo is typically located under the dashboard on the passenger side. You may need to remove the glove compartment for better access. The resistor is usually mounted to the HVAC unit, near the blower motor, and is secured by screws or clips. Make sure to disconnect the battery before attempting to replace it for safety.
On a 1997 Isuzu Rodeo, the oil filter is located on the bottom front of the motor beneath the fan.
where is blower control module located 2004 isuzu ascender
I own a 1994 Isuzu Trooper, the blower moter is located inside the truck under the glove box.
can you put a 3.3 out of a pathfinder in a isuzu rodeo
there is a resistor that controls the speed and should be near the blower motor its called blower motor resistor
It is either the fuse or relay. also check the heater/ ac control switch.
The thermostat in a 2001 Isuzu Rodeo V6 LS is located on the driver's side of the motor. It is the lowest part that can be seen bolted to the motor on that side. The location is below the EFI, or Electronic Fuel Injector (carburetor).
The blower motor on a 2004 Isuzu Axiom is located under the dashboard on the passenger side of the vehicle. To access it, you may need to remove the lower dash panel. The blower motor is typically mounted near the firewall and can be identified by its round shape and electrical connector.
YES!
The blower motor resistor for a 2001 Isuzu Trooper is typically located under the dashboard on the passenger side. You'll need to remove the lower dash panel to access it. The resistor is usually mounted near the blower motor itself, attached to the HVAC housing. Make sure to disconnect the battery before attempting any repairs for safety.