Under the hood on the driver side.
( 3 ) according to the owners manual
26.4 pints or 11.2 litres
In the brake master cylinder reservoir on the drivers side of the engine compartment near the firewall
In a 2001 Ford F-250 : ( DOT 3 brake fluid meeting Ford specification ESA-M6C25-A is used in the brake system )
Sounds like a master cylinder.
brake pressure loss and pedal going straight to floor is mostly caused by loss of brake fluid or air in brake system look under car and on inside of wheels to see if fluid is leaking. check brake fluid level at master cylander if no fluid seems to be leaking, have the brake system bled for air. this is the simplest remedy to start with if that doesnt fix it have the brake power booster checked to make sure fluis is not leaking into that also check on firewall in engine bay round booster for fluid and on inside of cab on firewall for fluid
Not knowing what year the truck is, my guess would be coolant. Check or monitor the level of all the fluids including brake fluid.
Yes, you can bleed the master cylinder on a 1983 Ford F250. To do this, you typically need to remove the master cylinder from the brake system, then fill it with brake fluid and pump the piston to expel any air bubbles. It's important to ensure the fluid is topped off throughout the process to prevent introducing more air. Always consult the vehicle’s service manual for specific instructions and safety precautions.
On the back of the pan.
The fuel pump on a 1979 Ford F250 is located on the side of the engine. It uses a mechanical rod to operate the pump directly from the vehicle's cam shaft.
replace brake light switch located on brake pedal under dash
Motorcraft fluids