The camshaft position sensor, also referred to as the TDC sensor, is located under the same cover as the timing belt. It is a good idea to check the condition of the timing belt and water pump if you are changing the camshaft position sensor.
position sensor on a 96 accord ex located
its inside the distributor
On the camshaft
take off timing belt cover....it is below it.
The crankshaft sensor on a 2 door Honda Accord with a 3L V6 engine is located on the side of the engine, near the oil filter. It screws into the side of the block and outputs the loading of the crankshaft to the vehicle's computer.
The Camshaft Position Sensor on a 2005 Honda Accord is typically located near the top of the engine, on the cylinder head. For the 4-cylinder models, it is usually found on the front of the engine, while for the V6 models, it is located near the rear of the engine, close to the camshaft. Accessing the sensor may require removing some components for better visibility and reach. Always consult the vehicle's service manual for specific guidance related to your engine type.
Yes, the 1999 Honda Passport is equipped with a camshaft position sensor. This sensor plays a crucial role in the engine management system by monitoring the position of the camshaft, which helps the engine control unit (ECU) optimize fuel injection and ignition timing. If the sensor fails, it can lead to performance issues or difficulty starting the engine.
The cylinder position sensor is located in the distributor.
Depending on the year it could be in the distributor or by the crank's pulley. On 93-98 Honda passports with the 3.2l engine the crankshaft position sensor in located on the passenger side of the engine near the engine mount. 93-95s did not have the camshaft sensor though. that was added in 96 and is located on the d/s valve cover in the outside upper corner
have you checked inside the distributor . good luck
PO365 problem with the circuit for the camshaft position sensor B, Bank 1
inside the distributor