0
What else can I help you with?
Where is the crankshaft position sensor on a 1999 Chevy Venture and how do you change it?
Where is the camshaft sensor located in 1997 Chevy venture
What does the code p 1345 mean for a Chevy 1997 pickup?
Code P1345 is for the crankshaft or camshaft position sensor.
What is a cam positioning sensor on a 1997 5.2 v8 dodge Dakota and why is it causing your check engine light to come on?
The cam sensor is inside the distributor and tells the computer the rotational location of the camshaft.
Where is the camshaft sensor located on a 1997 Chevy k1500 with a 5.7 liter?
Remove the distributor cap and rotor. It is the only electronic device that you will see. The cam sensor.
How do you replace the camshaft position sensor on a 1997 Plymouth voyager 3 L?
how do you replace the camshaft position sensor on a 1997 plymouth voyager 3l
Where is the map sensor 1997 Chevy?
Where is the map sensor on a 1997 Chevy 1500?
Where is the camshaft position sensor located on a 1997 rs camaro?
The position of the camshaft sensor on your 1997 Camaro is dependent upon the type of engine in the Camaro. In most cases the camshaft position sensor is on the back of the left-hand cylinder head.
Where is the camshaft sensor for a 1997 s10?
4.3L? In the distributor.
Why would there be oil in your camshaft sensor on a 1997 dodge neon?
Rear camshaft seal bad. Replace. located behind cam sensor.
Could a bad crankshaft positioning sensor make a 1997 Chevy blazer die while driving?
yes, and it will also make it sporadically not want to start.
Where is temperature sensor located on a 1997 2.4L Chevy cavalier?
Where is radiator temperature sensor located on a 1997 2.4L Chevy cavalier
How do you change cam sensor on 1997 chevy Lumina?
To change the camshaft position sensor on a 1997 Chevy Lumina, first disconnect the negative battery cable for safety. Locate the sensor, which is typically positioned near the engine block, and unplug the electrical connector. Remove the mounting bolt(s) securing the sensor, then take out the old sensor. Install the new sensor in reverse order, secure it with the bolt(s), reconnect the electrical connector, and finally reattach the battery cable.
